Jump to content
SAU Community

Recommended Posts

  • Replies 100
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Let you guys know that E.S.T is a streets car crew, we are not accociated with Seductive Motorsport as for they are a car show crew. That why I need to editing my first post in the thread so it was my mistake. sorry.

Cheers

Hmmm.....I might still drive past to check it out

is this cruise notified to the po po?!?!?!????

We will call up with cops and let them know that we doing a charity cruise. Everyone must be on their best behaviour and HOONING will not be tolerated and the police are notified of the cruise, please be sensible.

Edited by -i-b-u-k-i-

if you want to edit your first post you have to report your self and in the body of the report aks for the specific changes that you want and im led to believe moderators should be able to do it

Anyone know where can I editing my first post in my thread?

I need to change it asap.

if you want to edit your first post you have to report your self and in the body of the report aks for the specific changes that you want and im led to believe moderators should be able to do it

oh ok thanks steve and i will ask the moderators. So who is the moderators?

Cheers

Edited by -i-b-u-k-i-
c'mon pete would be good to get a GTR out there for the first cruz,

plus u would have the coolest car there. (unless a R35 GTR rocks up) (or a Z-Tune)

Lol...Norris, don't try to force people to attend the cruise if they don't want to. Its their choice in whether they want to come or not.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...