Jump to content
SAU Community

Recommended Posts

1997 Series 1 Nissan Stagea RS V Four StationWagon, 97500kms, Auto, RB25DET engine, Attessa 4wd, Silky Snow Pearl, Dayz bodykit, Fresh fluid throughout, 100,000km service done (new water pump, belts, exhaust studs, all fresh fluid throughout such as p/steer, radiator, attessa, etc):

Engine:

Ryco Z201 fuel filter, Ryco Z145 oil filter, Castrol Edge 0/40w engine oil

Davies Craig automatic transmission oil cooler upgrade kit

MV Automatic shift kit & auto service kit

Koyo Radiator upgrade

Splitfire coil packs

NGK BCPRE6 0.8mm copper v-gruve spark plugs

Bosch 040 fuel pump with direct battery feed at 13.8volts

Aerospeed adjustable exhaust cam gear pulley wheel

Greddy remote oil filter relocation kit

Nismo adjustable fuel pressure regulator

Nissan Z32 Air Flow Meter

3inch JustJap stainless steel single dump pipe system (turbo to cat)

3inch Catco high flow catalytic converter

3inch cat-back exhaust system with GTR Kakimoto racing free flow muffler

K&N pod filter

Cold Air Induction aluminium box w/ lid setup, foam internals, using standard snorkel air feed

Cold Air Radiator air guide (feeds radiator / pod / intercooler)

Apexi 'Hybrid' front mount intercooler, tube & fin and bar & plate, with custom return air feed pipe kit

Apexi boost gauge

Apexi SAFC Super Air Fuel Computer

Apexi SITC Super Ignition Timing Computer

Hybrid dual stage Electronic Boost Controller, set to 1bar and 1.1bar

HKS heavy duty turbo actuator

Sliding Performance water/oil cooled 360degree bush bearing Hi-Flow Turbocharger

Rated 250rwkw at 1bar, 2yr old 9000kms perfect condition. Easy stable 1.1bar

Toshi ecu remap

Suspension:

Bilstein front and rear suspension shocks, with ‘lowering’ circlips, using standard springs

Whiteline front and rear adjustable swaybars

Dayz adjustable engine swaybar

Whiteline front castor kit

Whiteline rear subframe alignment kit

R34 GTT 17inch rims with Hankook K104 Ventus tyres, 235/45/17

Brakes:

Maltech stainless steel braided brake lines, front and rear

DBA slotted front brake discs

Benidx Advance front and Heavy Duty rear brake pads

Audio:

Clarion stereo tape unit with 6-stack cd player

Clarion amp mounted to enclosure for Clarion 10inch subwoofer

Pioneer 260w 4-way front door speakers

Eclipse 80w 2-way rear door speakers

Razin volt stabiliser kit

Car alarm

Major,

It's funny but our vehicles share allot of similar mods. Probably the exact same exhaust... literally... intake less your cold air box, my car has a stock air box with a metal pipe jammed up it's rear to the elbow with a rubber joiner. different turb... Brake maintanence same except I have bendix ultimates ... dusty as hell. my FMIC setup is of a similar design though not as good quality probably ++ my piping work is pretty good. My exhuast cam gear is some cheap chinese knock off but it came powder coated with plenty of adjustment. I run 235 front, 265 rears.. which look shit.. but widest I could fit even after rolling the pannels etc. My management is in but is crap... greedy ultimate you were banging on about... jjr oil cooler kit etc.. just your everyday non-competitive track day setup.

>;p

I still love it.. will probably be defecting soon.

  • 4 weeks later...

well the remapped ecu is running real well

put in the Random Technology 617cfi cat converter this week, welded up to the old cat flanges and bungs, old cat was shagged.

runs so sweet

hiflow cat makes a massive difference, better fuel economy, more power

engine runs at 500rpm idle perfect, and gets to 2000rpm very easily off boost, turbo spools up and runs thru to 6500rpm and the shift kit changes quick

pulls past speedo needle, on private road of course

when warm, the exhaust back pops ect on off throttle from boost, sounds so sweet

will do a quick dyno tune for the piggybacks - safc/sitc and the fpr

the remapped Toshi ecu will take it in its stride

I "might" put in the 555cc injectors I have; will chat to shaun @ boostwerks now

either way easy 200awkw without injectors, 220 with

:ermm:

  • 4 weeks later...

pulled 200kw no worries with adjustment of the wastegate, but the bleed valve (Hybrid dual stage ebc) is letting it down, still drops boost

set at 1bar shes tuned nicely for 190awkw 1bar drop to 12psi (still !!!!!!!!!!!!)

way more in it as is, if it held boost the graphs show ~210kw

going to get a profec B eventually to fix it.

midrange has gained 10kw throughout, feels very nice. Hills run tonight ;)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...