Jump to content
SAU Community

Recommended Posts

Ordered mine today, gonna cost me closer to $60, apparently prices have gone up recently... and there is delivery :kiss:

btw, it looks like you can order direct from them on there website, not sure if its cheaper, but might be easier for those that aren't near a Repco http://www.protectomat.com.au/main.html

in the title of your thread you said "SICK OF REPAIRING THE BUBBLES IN YOUR DASH"

So have your repaired these bubbles before and if so how is it done....??

because if it is possible i would like to repair the bubbles first and then get the mat to protect it.

in the title of your thread you said "SICK OF REPAIRING THE BUBBLES IN YOUR DASH"

So have your repaired these bubbles before and if so how is it done....??

because if it is possible i would like to repair the bubbles first and then get the mat to protect it.

If we're talking about the same bubble (one circled in attached photo), I've heard that a heat gun and a piece of wood will get it down. Just heat up the affected area and push down with the piece of wood. I haven't tried it myself, but it could work.

post-32186-1212831056_thumb.jpg

had a look on the protectomat website but couldn't see it..? maybe i looked in the wrong spot though?

Nah not listed for reason explained in the beginning of the thread, however you can manually add the part number for your order, which is mentioned on the first page of the thread. Or just email them.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
    • I do have loctite 243 and 246 and a few more models. I could drill it now in place and make new threads for m12 and order an4 - m12 coupling and fit that to the turbo. Run a braided hose to the EBC which I could get a an4 to 1/8npt 
    • So M12 and sealant should be fine?    NPT ” because that’s what I had and what I could get atm. 
    • Wouldn’t touch par if they gave it to me. You need to ask how much power you’re looking to make and then add about 50% to it because that’s what you’ll end up making  The factory box says no more at about 350kw or so, the upgraded synchro boxes won’t handle much over 500kw for long and at that point you’re looking at an auto or dog engagement manual,  once you’ve gone dog engagement you may as well go sequential, they cost a little bit more but it’s worth it  also while you’re at it you should upgrade the transfer case with 10 friction plates 
×
×
  • Create New...