Jump to content
SAU Community

Recommended Posts

  • 3 years later...
I changed my GTS pump to a GTR V-spec pump, straight forward, only problem is getting that fiddly screw cap to thread back on. It was a direct swap, not sure what the talk about clamps is ??

Sorry to dig up a 3yr old thread (not sorry really :( )

I have an R33 GTR fuel pump a want to install shortly into my R33 GTSt

Can anyone else vouch for what Chook said that it is a 'direct replacement' ?

No need for brackets and the like?

Would like to hear from people who actually have this setup.

..and if that's the case, i have spare brackets if anyone needs em. :(

the gtr pump will be different at the bottom where it sits in the cradle with the rubber so you cannot use the gtst rubber there. that is why people use stainless cable ties/clamps to hold the pump to the bracket. also the hose at the top of the pump may be a bit long and need a little trim

that is about all, the sock on the bottom u can use on the gtr pump, also the wiring connections are the same (bolts through crimp lugs)

so its up to u how to mount it... with a rubber would be best i rekon because when they installed mine it vibrated loudly because of it being held onto the cradle with cable ties

Edited by tek_01

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The odometer does go up when driving.  Does this tell it is an issue with the speedometer itself?    Where can I look for replacement cluster? Or speedo? I can likely do the repair.. Will ER34 cluster work on HR34? Or do I need a HR34 20GT S2 specifically lol   
    • Mine's a bit bigger at 70x150mm roughly. The spots are flat, just can feel the edges if I dig my nail into it. I did fix some other other ones by both using my finger to sand that small spot (I'm a bit wary of doing this and creating hot spots and a bigger mess) and I also did sand over it flat and others, but this also worried me a bit because if I create an overall low spot on the panel on paint that is good.  Correct me if I'm wrong but as long as it's flat even if I can feel the edges, I can put filler because it will all be level once I sand it? I can see myself going in a circle after sanding guidecoat with 320 grit if for example the panel is flat with my hand but because I sanded the guidecoat I could have created a low spot again somewhere. Unless where I'm going wrong is what I mentioned previously where I didn't go low enough on the grits. It's 1 step forward and 2 step backwards here haha. I'll probably need to experiment with it more. Last time I go back to bare metal lol.
    • Thanks for the details mate , for me I think being a daily driven and happy with a basic tune (630Nm and 310kw) . Seems to be working well I just put on a set of Michelin Pilot Sport 4 should help put the power down. I'm going to start looking a brakes and LSD in the future so I might reach out to you on options to upgrade the brakes. Cheers - Dee   
    • I have a HR34 GT... RB20DE My speedo doesn't work! The rest of the gauges seem to work, fuel and RPM. I did not notice if my odometer was going up when driving last.  Any ideas? Speed sensor? Hopefully atleast... Gauge cluster perhaps? Or is that unlikely because the other gauges are working?   Any insight is appreciated. This is a rather new to me car. Lol 
×
×
  • Create New...