Jump to content
SAU Community

Recommended Posts

hey all.. i currently have just finished setting up my new turbo setup on my rb20 cefiro...

i have gtr injectors alreayd cleaned and flow tested and the dropping resistor which is need for the gtr injectors..

my question is once i have the injectors installed and resistor pack installed will the car run at all... i know it owuld be extremely rich if it did run at all

all i need is for it to run for maybe 2 hours, off boost so i can drive down to get a remap on my stock ecu...

cheers in advance :)

Link to comment
https://www.sau.com.au/forums/topic/223139-gtr-injector-help/
Share on other sites

With the power fc set on standard factory map we couldnt get the car(R32 RB20) to start after installing GTR injectors and resistor pack. We had to adjust the injector correction i think from memory using a calculation that is on paulr33's write up on power fc's.

So I dont think it will run, if u turn it over and it just keeps cranking then that will be the problem.. Just make sure when you brigde your resistor pack you are 100% the wires are connected/soldered properly.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • It is a kunfine Android screen . Does anyone know the wirering diagram of the fuga ??
    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
×
×
  • Create New...