Jump to content
SAU Community

Recommended Posts

Small drive shaft that runs between both motors on electric chairs(is at the front of the chair)

Reclining Motor cover on passenger side chair

Rear LHD door armrest plastic screw cover

Passenger and driver air vents (large and small ones)

boot lid popper button

bolt to hold down spare wheel

Have a few more little bits and pieces but let me know if you have any of this stuff

  • 2 weeks later...
  • 2 weeks later...
  • 2 months later...
  • 3 months later...
  • 2 weeks later...
spose i should reply to this. sorry for the delay, but you ended up getting your parts hey?

Yeah I did

I still havent fitted them.

Had some issues with new bushes.

I will have to stick up photos as it was a massive problem making nolathane bushes fit on the lower control arms

  • 4 weeks later...

hey mate it has passenger front door missing drive line gone, all other panels, seats and trims, all cloth is badly sun damaged, it has no rear arms or diff or axles, would want about $600 but its pretty much usless unless you have a crashed cima..

give me a sms if you want 0450929227

Edited by E-Z
  • 3 months later...
  • 2 years later...
  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • There are black hose clamps as well if you care. Plazmaman for example sells some: https://plazmaman.com/product/black-hose-clamps-premium-quality-stainless-breeze/
    • After using a protractor for an actually accurate assessment of what is required,  and by NOT using my uncalibrated eyeball I worked out I need a 25° silicone bend from the TB ro the MAF, but, my choice was either a 30° or a 23° (23° is a weird spec), so I grabbed the 23° one from Raceworks I also grabbed 1mtr of 3" straight from Just Jap, I needed 350mm, but they only had 300mm, or 1mtr lengths....meh Also ordered a 1/2" hose bulkhead fitting from fleabay, this has a smoothish mushroom looking head (they are designed for below the water line of boats) that will fit inside the bend, the hose bit and threaded bit looks to long, but nothing that a hacksaw cannot fix if required, the hose will then just get jamed on the threaded bit up to the retaining nut Fingers crossed and the unsightly amount of hose clamps will be reduced down to 4 once all the parts arrive 
    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
×
×
  • Create New...