Jump to content
SAU Community

Recommended Posts

As above, what's the best day? Right now I'm leaning towards saturday because then we could go have drinks after, but if sunday is going to be better then I'll go then lol.

Edit: Lol I just realised that's my first new topic since 2006, and my third one ever.

Edited by s2k12
Link to comment
https://www.sau.com.au/forums/topic/229632-best-day-to-go-to-autosalon/
Share on other sites

Saturday, then straight after..go pub for abit..then hit Eurobar for the autosalon after party..

then go sunday with hang over..

Haha, problem with that is I'm only 17, so unless they serve me without an ID check..

the best day to go to autosalon is NEVER.

just go to the carpark - that's where all the good cars are, why? because the cars parked there have had money invested in the CAR.. not in the $300 or wahtever that you have to pay to enter racewars

actually

if you were to break into cars that day., would be a GREAT cleanup

i mean SERIOUS!



  • Similar Content

  • Latest Posts

    • Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Didnt realise RB's had more then 1 head.
    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...