Jump to content
SAU Community

Recommended Posts

3.25inch Blitz NUR exhaust for R32 GTSt.

full stainless steel, cat-back.

cannon resonator and muffler with 4.5inch tip

scratches on resonator and only a few on piping and muffler.

overall very good -> excellent condition.

$700 ono

in Melbourne

[email protected]

0409 942 006

Link to comment
https://www.sau.com.au/forums/topic/23029-blitz-nur-exhaust/
Share on other sites

  • Replies 42
  • Created
  • Last Reply

Top Posters In This Topic

structurally its all fine except that the bottom lip has been cracked, repaired with a dodgy paint job in japan and then cracked again by myself. it also has a few paint chips, but the bar will need to be resprayed anyway after the lip is fixed.

i think i might hang out for a modified gtr bar if i can. if not then ill keep you in mind.

Link to comment
https://www.sau.com.au/forums/topic/23029-blitz-nur-exhaust/#findComment-507486
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hope you aren't too sore after that one, might take a day or 2 to notice yet and I guess it is a loooooong drive home. On the bright side, tube frame front end is a thing at superlap, right?
    • https://www.facebook.com/share/p/18rmVb1SKB/ 
    • The chart of front pressure to rear pressure (with one being on the x axis and the other being on the y axis) is not a straight line on a typical proportioning valve. At lower pressures there is a straight line with one slope, and at higher pressures that changes to a lower slope. That creates a bend in the line at that pressure, called the knee point. If you do not change the proportionng as the pressure gets higher, you will suffer excessive pressure (at one end of the car or the other, depending on which way you look at the proportioning action) and then get lockups at that end. The HFM BM57, from my memory of previous discussions, is based on the BM57 from a different car (to a Skyline), with a different requirement for the location of the knee point and the distribution of pressure front to rear, and so is not a good choice for an upgrade on a Skyline. Here's a couple of links to some old posts, one from here, one from elsewhere. A lot of it pertains to adjustable prop valves, but the idea is the same. There are plenty of discussions on here about this issue from al the many years of people wanting a cheap/accessible option. https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/ https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/  
    • Yeah dunno why johhny posted that here with no context, just post on FB/insta bro where he put it up?  Laine had an off at T4 during Thurs prac, he's ok, car is less than perfect, they are done for the weekend, he can fill in the rest. Bando also binned it like 100m up the road.   
    • I feel there must have been a FB/insta post and the weekend did not start well at all I hope everyone is all okay
×
×
  • Create New...