Jump to content
SAU Community

Recommended Posts

  • Replies 59
  • Created
  • Last Reply

Top Posters In This Topic

- HSD GTR/GTS4 coil overs - $800 (not even 5000kms use)

- RB30 bottom end, just completed run in (CP forgies, ACL race series bearings, twin cam oil pump, oil restrictors, etc, etc) - $2500 (custom sump can be added for a bit more)

- Pivot shift light - $50

- Pivot speed meter - $70

  • 1 month later...

T88-33D genuine Trust turbo (freshly rebuilt with GT42 front wheel) - $1700ono

Pivot speed meter and shift light - $100 for both

HSD R32 GTR/GTS4 coil overs only traveled 5000kms - $800ono

  • 2 weeks later...
  • 2 months later...
  • 2 weeks later...

they weren't for sale anymore but i guess for the right price ill let em go

they go about 4 inches below stock

its so close to the ground its impractical

$850 delivered and they're yours

I'll give you $750 delivered mate.

Could you possibly get me some photos though.

Are they the GTR model or the GTS-4/T model?

Would like to know which model and therefore the springrates.

PS. I would had pm'd u back but my msg composer is stuffing up.

thanks.

Edited by wpnsx

they are GTR/GTS4 model

GTSt ones have different rear mounts

they are the HR series

ill have to pull em out of the car tomorrow to get pics

If you promise they will fit in my gtr Im fine with that mate.

Im not too fussed about the photo's of them mate if they have only done 5000km they should be in pretty good nick yeh?

The reason I want them is my car has coilovers in it now and these coilovers (tein) are not allowing me to lower it to where I want it.

The total height of my car now (at lowest setting) is 1280mm. So that should have only dropped about 60mm. Another 50 or so and Ill be happy.

Here is my email address please send me something and I will reply some photos of my car so you can see how high it is and compare it to yours.

[email protected]

Thanks heaps mate,

PS. Sorry for dicking you round I just wanna try and avoid doing $800 on coilovers and not gaining anything.

  • 2 weeks later...
  • 3 weeks later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...