Jump to content
SAU Community

Recommended Posts

no way keep the badges - the boot is to boring without them - maybe with a nice lip spoiler it would be ok but otherwise... I would not have taken off the SKYLINE if you are keeping the NISSAN badge - I think all badges or none at all (with a spoiler) are the only options...

2892_rear_r_107.jpg

2887_rear_rl_234.jpg

  • 4 years later...

whats different about the 07 lights?

-mark

The only difference I see in regards to the '07 vs '04 lights is that the reverse lights on the '07 are rectangles.. They're clear round ones on '04 lights..

On another note, mine had the Nissan taken off, and an infiniti grill put on! I need to change that very soon, I think!

Edited by Ninja_Nate

The only difference I see in regards to the '07 vs '04 lights is that the reverse lights on the '07 are rectangles.. They're clear round ones on '04 lights..

On another note, mine had the Nissan taken off, and an infiniti grill put on! I need to change that very soon, I think!

03 to mid-06 lights

- flat face

- round reverse light

- halogen light for running light

- leds in circle for brake

- leds closest to boot lid are 4,4,4 pattern

mid 06+ lights

- they have 'recessed' areas over the lights - stove top design like R34' - not flat.

- square reverse light as stated

- led running lights in the circle

- led brake lights

- led's closest to bootlid are a 3,4,5 pattern

- boot release button on LHS light

i did a language conversion on a V35 coupe that had this badge..

the Prince skyline badge

looked pretty neat against the blue.

6283268655_af330ac5c6_z.jpg

hey mate how much do you charge for the conversions if I may ask? And you in Melbourne I presume?

can you PM me a cost?

cheers

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...