Jump to content
SAU Community

Recommended Posts

wow thats really bad i get 460 to a full tank and i drive normal and not so everynow and then and travel to muno and back all the time

i have a S2 with a 4" full system no cat or mid muffler and custom dump.

you should get that looked at

i used to use BP now i use mobil so what fuel you use

Link to comment
https://www.sau.com.au/forums/topic/242420-petrol-question-for-all-r33-owners/
Share on other sites

  • Replies 41
  • Created
  • Last Reply

Top Posters In This Topic

How many Km's do you'se guys get out of a full tank of petrol?

I get about 320-350 when I drive my car sensibly and dont drive lead footed

My car is fairly stock tho, appart from a cooler and 3 inch turbo back

Is this average, or whats going on here?

well my fuel sensor is weird! at the bottom half of the tank i get around 100km and the top half around 200-250km

mine used to do the same till i lost economy i used to got 200+ kms before the gauge started moving now its around the 125 mark

all up i can push 400 out of it fuel light comes on @ about 300ish i used to not get the fuel light even little past 350

very inaccurate way of checking fuel consumption guys cause if the gauge isn't reading correctly, you could still have 100km's left in the tank when the light comes on.

Fill up & zero your counter, fill up again when your light comes on then make note of your odometer & litres used and divide one into the other.

The past 3 fuel tank in the last week or so I've been getting about 450km out of the tank, and that is with hard hills driving included + boosting hard with each fill up! and when I fill up I still have something about 6-9L left. Using BP Ultimate, about 180rwkw untuned.

I installed new coil packs just before i filled up the other night, and i reset the counter. I havent measured the amount of k's from a full tank for a few years now, and i've added a few mods to the car since i last measured it. i'll be interested to see if i can get over 350km's.

I think my stock ecu is making the engine run R&R - i get this massive creep of power after 5500rpm (the car literally throws me back in my seat); through the midrange its somewhat weaker. Not nice!

Need to do some investigating... The time for a powerfc and tune may be here...

Hey crew,

I get roughtly 11-12L/100kms, and have even been in the 10s. Fuel per tank is about 500-550kms.

This is with 11psi, FMIC, Full exhaust, and a fairly heavy right foot when in the mood - frequently :P

I might be one of the lucky ones with my ECU by the sounds of things. Come to think of it, even with higher boost, I have never felt flatspot, or R&R, that is commonally mentioned.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
×
×
  • Create New...