Jump to content
SAU Community

Recommended Posts

wow thats really bad i get 460 to a full tank and i drive normal and not so everynow and then and travel to muno and back all the time

i have a S2 with a 4" full system no cat or mid muffler and custom dump.

you should get that looked at

i used to use BP now i use mobil so what fuel you use

Link to comment
https://www.sau.com.au/forums/topic/242420-petrol-question-for-all-r33-owners/
Share on other sites

  • Replies 41
  • Created
  • Last Reply

Top Posters In This Topic

How many Km's do you'se guys get out of a full tank of petrol?

I get about 320-350 when I drive my car sensibly and dont drive lead footed

My car is fairly stock tho, appart from a cooler and 3 inch turbo back

Is this average, or whats going on here?

well my fuel sensor is weird! at the bottom half of the tank i get around 100km and the top half around 200-250km

mine used to do the same till i lost economy i used to got 200+ kms before the gauge started moving now its around the 125 mark

all up i can push 400 out of it fuel light comes on @ about 300ish i used to not get the fuel light even little past 350

very inaccurate way of checking fuel consumption guys cause if the gauge isn't reading correctly, you could still have 100km's left in the tank when the light comes on.

Fill up & zero your counter, fill up again when your light comes on then make note of your odometer & litres used and divide one into the other.

The past 3 fuel tank in the last week or so I've been getting about 450km out of the tank, and that is with hard hills driving included + boosting hard with each fill up! and when I fill up I still have something about 6-9L left. Using BP Ultimate, about 180rwkw untuned.

I installed new coil packs just before i filled up the other night, and i reset the counter. I havent measured the amount of k's from a full tank for a few years now, and i've added a few mods to the car since i last measured it. i'll be interested to see if i can get over 350km's.

I think my stock ecu is making the engine run R&R - i get this massive creep of power after 5500rpm (the car literally throws me back in my seat); through the midrange its somewhat weaker. Not nice!

Need to do some investigating... The time for a powerfc and tune may be here...

Hey crew,

I get roughtly 11-12L/100kms, and have even been in the 10s. Fuel per tank is about 500-550kms.

This is with 11psi, FMIC, Full exhaust, and a fairly heavy right foot when in the mood - frequently :P

I might be one of the lucky ones with my ECU by the sounds of things. Come to think of it, even with higher boost, I have never felt flatspot, or R&R, that is commonally mentioned.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Hi guys . Can someone help me  I bought an Android screen for my Nissan fuga but it won't turn on   
    • My guesstimate, with no real numbers to back it up, is it won't effect it greatly at all.its not a huge change in position, and I can't see the air flow changing from in turbulence that much based on distance, and what's in front of it. Johnny and Brad may have some more numbers to share from experience though.
    • Which solenoid? Why was it changed? Again, why was this done? ...well, these wear..but ultimately, why was it changed? Did you reset the idle voltage level after fitment? I'm just a tad confused ~ the flash code doesn't allude to these items being faulty, so in my mind the only reason to change these things, would be some drive-ability issue....and if that's the case, what was the problem? Those questions aside, check if the dropping resistor is OK ...should be 11~14 ohms (TCU doesn't throw a flash code for this) ~ also, these TCU designs have full time power (to keep fault code RAM alive), and I think that'll throw a logic code (as opposed to the 10 hardware codes), if that power is missing (or the ram has gone bad in the TCU, which you can check..but that's another story here perhaps).
    • Question for people who "know stuff" I am looking at doing the new intake like the one in the picture (the pictured is designed for the OEM TB and intake plenum), this design has the filter behind the front bar, but, the filter sits where the OEM duct heads into the front bar, and the standard aperture when the OEM ducting is removed allows the filter to pulled back out of the front bar into the engine bay for servicing, a simple blanking plate is used to seal the aperture behind the filter This will require a 45° silicone hose from the TB, like the alloy pipe that is currently there, to another 45° silicone hose to get a straight run to the aperture in the front bar Question: how will it effect the tune if I move the MAF about 100-150mm forward, the red is around where my MAF is currently, and the green would be where it would end up Like this This is the hole the filter goes through  Ends up like this LOL..Cheers    
    • Despite the level up question, actually I do know what that is....it is a pressure sender wire.  So check out around the oil filter for an oil pressure sender, or maybe fuel pressure near the filter or on the engine. Possibly but less likely coolant pressure sensor because they tend to be combined temp/pressure senders if you have one. Could also be brake pressure (in a brake line somewhere pre ABS) but maybe I'm the only one that has that on a skyline.
×
×
  • Create New...