Jump to content
SAU Community

Recommended Posts

hi guys & girls

i have the following for sale. preffer pick up, but i can send if its worth it to you.

r34 triple gauge cluster (gauges only, no surround cover) used condition $40

r34 fuel pressure regulator. used condition $10

r34 traction control throttle body (only good for tcs motor, body is hacked up) $10

r34 air flow meter (pink sticker, good for pod filter only as square section has been cut off) used $50

r34 timing cover used $30

r34 stock turbo (only good for housings front +rear...no shaft/blades) $30

r34 stock rubber intake tube. used. $10

R34 turbo heat sheild. used. $10

r34 wastegate modified braket. used. $10

r34 stock fuel rail and injectors. used. $90

r34 amber front blinkers. used. $20

r34 amber side blinkers. used. $10

r34 bare intake plenum top and bottom sections. used. $100

r33 6 stock injectors (one missing the plastic at bottom, see pic). used. $40

r33 amber side blinkers. used. $10

pick up is Dharruk just near rootyhill

i need this stuff gone, if not sold here it will be put on ebay, so all offers considered.

Justin

0408 589 335

post-1416-1226743255_thumb.jpg

post-1416-1226743297_thumb.jpg

post-1416-1226743333_thumb.jpg

post-1416-1226743354_thumb.jpg

post-1416-1226743374_thumb.jpg

post-1416-1226743403_thumb.jpg

post-1416-1226743443_thumb.jpg

post-1416-1226743470_thumb.jpg

post-1416-1226743498_thumb.jpg

post-1416-1226743521_thumb.jpg

post-1416-1226743545_thumb.jpg

post-1416-1226743567_thumb.jpg

post-1416-1226743586_thumb.jpg

post-1416-1226743603_thumb.jpg

post-1416-1226743630_thumb.jpg

post-1416-1226743648_thumb.jpg

Shotgun the...

-fuel p reg

-turbo

-intake pipe

-heat shield

-wastegate

-and 34 fuel rail + injectors

Message and pm sent!

Payment made!

Thankyou

Edited by chriz
  • 5 months later...
Any chance of the TCS motor still available ?

yes its still available, as stated its good for the tcs motor only, the round pipe section has been cut.

Thanks

Justin

turbo still available by any chance?

thanks

no sorry

turbo sold

turbo heat shield sold

wastegate actuator sold

r33 injectors sold

r34 fuel rail+injectors sold

turbo rubber intake tube sold

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For fuelling the Haltechs have O2WB fuel controllers. Very useful for helping tuning VE and correcting for *small* mistakes. Of course if your injector/cam/trigger/sensor data is just wrong (or for a GTT which is not a GT) then you will get impossible reactions to things. I am sure you know this already but the reason people don't typically put haltechs (or any Aftermarket ECU) on GT's is because there's practically no real gains to be had - So this knowledge won't be commonplace.
    • Can someone tell me if the cracks seen in the rear sway bar bushings in these photo's is unacceptable from a roadworthy point of view?  
    • Shouldn't need a "base map" for anything other than guidance to ignition tuning. You just need the engine capacity right, the injector size right, and something, almost anything, for a VE map. On an NA engine, fuelling is almost completely a function of load signal & rpm. It should run and drive with a completely flat fuel map. It will be too lean under load, but that's easily fixed. We used to tune all ECUs without any base map. There were no such things (until someone had tuned a near stock engine on one, and then they had a "base map".
    • What did you actually buy/how much did it cost? When I got mine in like.. 2017...? 2019? the aim was to run Torque for gauges via ODB2 and things like Track Addict/Laptimers/Dashcam/Reversecam/Spotify etc. Mine never broke, but I wonder if you've got the same needs (it sounds like it). Cause I liked the idea of being able to do anything with it. That said, yours also cost 3x the cost of what I spent so... food for thought.  
    • For me there is a massive difference in manufacturer or big brand crippled android (Sony, Kenwood etc) vs the sort of thing I've installed here, which is basically just a tablet in DIN form factor with open Android, and the other model of course is mirroring - Android Auto/Carplay. I hate the locked down manufacturer and AA options where they decide what apps I'm allowed to install, including the Launcher but also importantly things like Ecutek (for this car) or Real Dash (Stagea) are not supported. Plus those crippled versions tend to be slower due to both overheads and lower spec hardware. On the other hand, when this breaks I'll likely be in trouble for support....but how is that different to owning an Infiniti anyway
×
×
  • Create New...