Jump to content
SAU Community

Recommended Posts

these came on my stagea but i've replaced them with something slightly different

18x8+23 all round (sit 6mm in from r34GTR wheel so sit VERY nicely ;) )

high disk fronts clear brembos

low disk rears have more dish

come with centrecaps

no tyres

900ono, throw some money in my direction and you never know :D

100_0628.jpg

100_0629.jpg

can get more pics on request :(

  • 2 weeks later...

Hey M I K E

You may want to check they are the same offset front and rear

Looking at the the pics, the wheels on the right hand side of pic have less outer rim dish than the ones on the left.

I think it is possible they are the same offset, but the front rims may have a higher caliper offset clearance

Measure from the inside edge of rim to the inside face of the hub to confirm offsets

Hey M I K E

You may want to check they are the same offset front and rear

Looking at the the pics, the wheels on the right hand side of pic have less outer rim dish than the ones on the left.

I think it is possible they are the same offset, but the front rims may have a higher caliper offset clearance

Measure from the inside edge of rim to the inside face of the hub to confirm offsets

hey darren,

i'm 100% positive the offsets and widths are identicle on all 4 wheels (trust me, i know my wheels)

as i've stated in the first post, the rears are low disk and the fronts are high disk for caliper clearance - disk type also determines the amount of dish ie you can either have more dish or bigger caliper clearance but you can't have both

for anyone confused, because the fronts clear brembos, the back area of the wheel where it mounts to the hub needs to be deeper (high disk) to accomodate them which pushes the face out and we lose dish. the rears don't clear anything (low disk) besides rear brakes (and probably s13 front calipers LOL) and we see more dish

if anyone is still confused pm me and i'll take photos to demonstrate :)

aw nice. When I get back from Darwin, if these wheels are still for sale, I'm definatly interested.

edit: just noticed the original post date. are they still for sale?

Edited by Silhouette31

yeah still up for grabs, most of the offers have been from interstate however i don't have the time to post at the moment.

give me a bell when you get back and see what the go is :)

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Hello everyone, I am happy to join you.
    • Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...