Jump to content
SAU Community

Recommended Posts

hey guys,

This might been posted but anyways,

Im going over the pits agian to register my car!

Last time i went over i didnt pass due to Oil leak in rear shockies. zaust leak.

I have got Coil's now and welded the stock zaust back up.

Since i have that paper that states they (should really check only that) they can still check the rest of the car!

Since then i have put on an intercooler, has anyone been picked on with it do the check ? do they care

any help be great!

- RICCA

Link to comment
https://www.sau.com.au/forums/topic/245662-pits/
Share on other sites

I've got a FMIC which they didn't have a problem with. I imagine if it wasn't installed very well and parts of your front bar have been cut then they might have a problem with it. If there are obvious problems with the car then they'd pull you up about them, but each time I went back they just checked the items on the list and took all of 5 mins. It's really dependent on the inspector unfortunately...

Link to comment
https://www.sau.com.au/forums/topic/245662-pits/#findComment-4273042
Share on other sites

This thread is not required,

Ricca please use the search function.

This topic has been covered many times before.

You yourself posted "This might been posted but anyways"

Please read / use the search function prior to just posting.

As per the forum rules.

Cheers

Mike

Link to comment
https://www.sau.com.au/forums/topic/245662-pits/#findComment-4273847
Share on other sites

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...