Jump to content
SAU Community

Recommended Posts

With the ignition off I'm looking at the fluid bottle in the back and this is what I see.

Is this normal? notice that it is pretty far above "max" and also it appears to be two

colors of fluid. This is with ignition off.

The manual says "turn ignition ON make sure that oil is within max-min lines on the

tank.. if the ignition switch has been turned off for a long period of time oil in the

attesa e-ts pro actuator might return to the reservoir tank, causing oil to exceed

max line. Be sure to turn ignition switch on before checking oil level. Always use genuine

nissan power steering fluid .." (etc)

I've got an attesa ecu error of some kind, so perhaps the oil is returning to the reservoir

and not being pumped into the system, but why is it two colors like that?

post-51561-1227590251_thumb.jpg

Edited by r34nur
Link to comment
https://www.sau.com.au/forums/topic/246361-attesa-fluid-level/
Share on other sites

  • 2 years later...

I had attesa 4wd light\limp home issues with my Stagea, I found that checking the level after start up got the real picture of where it's at. Seems to bleed fluid back to bottle when parked up - maybe why so much headroom above level marks. I changed the fluid by loosening off bleed valve at back of trans & draining about 100mls at a time then top up the tank, with the ign turned on pump did not start but found that starting up motor then after several seconds the attesa pump would cycle up to pressure and draw the fresh fluid in. Rinse & repeat until the fluid turned red where I was draining it.

Probably better ways of doing it but it worked & all is at peace with the 4wd light.

With hindsight I didn't have to change fluid, just learnt to check level after startup.

Dunno 'bout the tequila sunrise effect in the pic but the level looks about where mine is when parked up for several hours.

Caveat: I'm new to this stuff & learning my way around my car.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Then, shorten them by 1cm, drop the car back down and have a visual look (or even better, use a spirit level across the wheel to see if you have less camber than before. You still want something like 1.5 for road use. Alternatively, if you have adjustable rear ride height (I assume you do if you have extreme camber wear), raise the suspension back to standard height until you can get it all aligned properly. Finally, keep in mind that wear on the inside of the tyre can be for incorrect toe, not just camber
    • I know I have to get a wheel alignment but until then I just need to bring the rear tyres in a bit they're wearing to the belt on the inside and brand new on the outside edge. I did shorten the arms a bit but got it wrong now after a few klms the Slip and VDC lights come on. I'd just like to get it to a point where I can drive for another week or two before getting an alignment. I've had to pay a lot of other stuff recently so doing it myself is my only option 
    • You just need a wheel alignment after, so just set them to the same as current and drive to the shop. As there are 2 upper links it may also be worth adding adjustable upper front links at the same time; these reduce bump steer when you move the camber (note that setting those correctly takes a lot longer as you have to recheck the camber at each length of the toe arm, through a range of movement, so you could just ignore that unless the handling becomes unpredictable)
    • I got adjustable after market rear camber arm to replace the stock one's because got sick of having to buy new rear tyres every few months. Can anyone please let me know what the best adjustment length would be. I don't have the old ones anymore to get measurements. I'm guessing the stock measurement minus a few mm would do it. Please any help on replacing them would be fantastic I've watched the YouTube clips but no-one talks about how long to set the camber arm to.
    • Heh. I copied the link to the video direct, instead of the thread I mentioned. But the video is the main value content anyway. Otherwise, yes, in Europe, surely you'd be expected to buy local. Being whichever flavour of Michelin, Continental or Pirelli suits your usage model.
×
×
  • Create New...