Haltech Interceptor On Rb25det

[Ninja_09]

Hi everyone!!!

I've just signed up on the site so I'm not sure what am doing and if I'm in the right section.

I had the R33 S-II for about a year and got an Interceptor fitted. Eve since I had it I have issues with ignitions around 3.5 - 4K RPM.

being through 3 different tuners and spent a fortune but same story.

Just wondering if anyone’s successfully done this before?

the car is converted to Manual and got a high flowed turbo , greddy ele. boost controller

Thanks in advance !!!

[Pal]

try give my tuner a ring, he's in WA and will point you in the right direction. he is a haltech guru

Aaron

in tune performance (bibra Lake)

(08)94346608

Eric

[Ninja_09]

try give my tuner a ring, he's in WA and will point you in the right direction. he is a haltech guru

Aaron

in tune performance (bibra Lake)

(08)94346608

Eric

Thanks Eric... Will try first thing tomorrow !!!

I was thinking if this is useless, then get Nistune done. Has anyone done Nistune on a R33 series 2 before. because ignition/ coil packs are different in series I and series II ???

Any ideas pls????

[QWK32]

i don't think nistune do a board for the R33, S1 or S2. also having the ignitors in the coils doesn't make a difference to the ecu. you've converted to manual, there are better options for engine management out there.

[Ninja_09]

i don't think nistune do a board for the R33, S1 or S2. also having the ignitors in the coils doesn't make a difference to the ecu. you've converted to manual, there are better options for engine management out there.

Thanks for the reply mate !! I know there are few different options out there but it all comes down to the cost of goods and installation then of course tuning. Nistune works out cheap even if I did it using a RB20 ECU, but the question is does this setup work on R33 S-II. I heard it works fine on series I cars coz the ignition is same in RB20 and RB25 series I.

Other option would be to find a 2^nd hand PFC…

[QWK32]

shouldn't be a problem, just have to check all the pinouts and match them up. all that comes from the ecu is the ignition signal, in 32's an S1 33's it goes to an ignitor pack which then fires the coils, in the S2 the signal goes straight to the coil which has a built in ignitor. the signal is the same from the ecu, just handled differently at the engine side of things.

[Ninja_09]

shouldn't be a problem, just have to check all the pinouts and match them up. all that comes from the ecu is the ignition signal, in 32's an S1 33's it goes to an ignitor pack which then fires the coils, in the S2 the signal goes straight to the coil which has a built in ignitor. the signal is the same from the ecu, just handled differently at the engine side of things.

mmmmm that explains a lot and makes sence. !!!!

Had a chat to Andrew from Hyperdrive today and also Sam from Dr Drift who's got a daughter board for R33 ECU ($1100). So I guess I can either use RB20 ecu and Greddy MSS(for VCT) to do Nistune or get Sam to install the daughter board onR33 ecu and make it tuneable. I'm wating to hear back from Andrew coz after all he the tuner. I'm paying for not consulting a / the tuner and buying an Interceptor which cannot be properly tuned on a R33. I spoke to Aaron from In Tune today, he's willing to check the wiring and do few test ot see what's wrong but I think it's best to just remove the Interceptor and get a fully functional and well tuneable ECU rather than a piggyback..