Jump to content
SAU Community

Recommended Posts

Use the search for "ATTESSA":

http://www.skylinesaustralia.com/forums/At...l=attessa+codes

Good hints in there. Best to check the error code and fill the resevoir with fluid - but you have to do that with the car running to get the level right.

There should be a little gauge on the dash above your fuel gauge, this shows torque split via ATTESSA. If you accelerate, this should go up and down depending on the power being pushed down, if this is not happening, ATTESSA is disengaged, and the fuse and link will need to be checked.

B.

on a 32 the torque guage, only activates when required, if your 4wd light is on, then most likely theres a problem. Open the boot, stick your head under there, and find the box on the left hand side under the parcel shelf, it should have a site glass which is flashing out codes over and over, write down the flashes till they cycle through ( theres a pause between each one) then do a search on the codes, theres a few threads on the codes.

dug these codes up from one of my old threads

have a look:

Dug these codes up from an ancient post.

4WD CODES:

LED FLASHES

1. Right front wheel speed sensor or circuit

2. Left front.........

3. Right rear........

4. Left rear.........

5. ABS right front wheel actuator solenoid or circuit

6. ABS left front.......

7. ABS REAR wheel.......

8. ABS actuator motor, motor relay or circuit

9. ABS actuator relay or circuit

10. ETS control unit power supply or circuit

11. Fore aft G sensor 1 or circuit

12. Fore aft G sensr 2 or circuit

13. Fore aft G sensor 1, Fore aft G sensr 2

14. G sensor power supply 1

15. G sensor power supply 2

16. Lateral G sensor or circuit

17. Air bleed connector or circuit

18. ETS pressure switch or circuit

19. ETS motor, motor relay or circuit.

20. ETS solenoid or circuit

21. THROTTLE sensor or circuit

22. ETS oil level switch or circuit

23-

24 or continually ON or OFF: ETS control unit, ground or ciruit.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
    • Either the bearing has been installed backwards OR the gearbox input shaft bearing is loosey goosey.   When in doubt, just put in a Samsonas in.
×
×
  • Create New...