RB25DET parts needed

By kik-ass,
September 15, 2003 in General Automotive Discussion

https://www.sau.com.au/forums/topic/24876-rb25det-parts-needed/

Followers 0

Recommended Posts

kik-ass

Posted September 15, 2003

- Share

Posted September 15, 2003

Help! I have a couple of exhaust manifold studs sheared off inside the head of my R33. Only noticed it when I was under the car putting a new dump pipe in. Has anyone else had this problem? I need to source a new exhaust manifold gasket and head gasket as well as a complete set of new manifold studs ( of higher quality than stock). Does anyone know where I can source these in QLD?? Any help would be greatly appreciated, I need to get my car back on the road asap. PM or reply here, or email [email protected]

Link to comment

https://www.sau.com.au/forums/topic/24876-rb25det-parts-needed/

Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign in

Already have an account? Sign in here.

https://www.sau.com.au/forums/topic/24876-rb25det-parts-needed/

Followers 0

Go to topic listing

Announcements

Similar Content
- 6
  
  RB25det
  
  By Julsmadrid
  Started June 28
- 1
  
  S2 Rb25det
  
  By rb25ceffy0
  Started June 5
- 10
  
  RB25DET NEO Cylinder Head
  
  By BOLGE
  Started May 18
- 96
  
  Stock rb25det neo questions
  
  By Wazmond
  Started March 17, 2024
- 2
  
  Looking for a part number for this part here
  
  By eli995
  Started June 8
Latest Posts
- Starting again
  
  By Ozdavroz · Posted 2 hours ago
  
  Thanks GTSBoy, much easier to work with it now it's free!
- Starting again
  
  By GTSBoy · Posted 4 hours ago
  
  I _think_ that one has a christmas tree or some other retainer spike into a hole in that panel under it. Come in under it with thin scredrivers and just pry it gently up. If you rip the ears off the retainer pin....so what? Just stick it back down after with a bit of race tape and carry on with life.
- Starting again
  
  By Ozdavroz · Posted 4 hours ago
  
  Here's a pic of the damn thing
- Starting again
  
  By Ozdavroz · Posted 4 hours ago
  
  Have pulled the fuel pump hanger out of the tank, wires all look good and still connected. Plenty of old dried up fuel caked on everything. i got a new DW200 pump to replace the old one, thought it was a good idea while I've got everything out. What's the trick to getting the blue fuel pump harness disconnected from the boot floor? Just rip it out?
- How To: "Refabricate" a Stagea 260RS/R33 GTR Speedo Sensor
  
  By GTSBoy · Posted 5 hours ago
  
  I got news for you. This is probably how you have a low mileage car in the first place!

Sign In

RB25DET parts needed

Recommended Posts

kik-ass

Link to comment

Share on other sites

Create an account or sign in to comment

Create an account

Sign in

Announcements

Similar Content

Latest Posts

Forums

Activity