Jump to content
SAU Community

Want To Borrow R34 Dash

ashneel

By ashneel,
in Victoria

 Share

Recommended Posts

ashneel Grand Master

ashneel

Posted
Posted

hey guys

for those that may not know im in the process of trying to get polished dash rings made for R34's as per thread here CLICK ME id pull mine out but will ne much easier if i could work on one thats already out.

so what i need is an R34 dash to borrow if you have a spare sitting around. all i need to do is un-clip the plastic face and take measurements of the gauges inside, depths among other things.

to make sure its all secured and that i wouldnt run away with your dash a small deposit can be left behind (or my details taken) and obviously ill take responsibility of any damage if it does get damaged.

so ye

anyone??? im in rowville willing to travel to pick it up and drop it off. if you on the SE suburbs ill only need it for about couple of hours. can come to yours and measure it up.

ta

Ash

Link to comment
https://www.sau.com.au/forums/topic/252270-want-to-borrow-r34-dash/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      NC MX5

      By MBS206 · Posted

      This sounds like someone who would have owned an R33 in their past... It's okay, I'm 100% picking up what you're putting down Mark.
    • MBS206
      Jacks that fit under GTR lips that can reach the subframe?

      By MBS206 · Posted

      Just back on what was raised about jacking off the the tow/tie down point on the front of cars. I've used it plenty. I've also watched it on a car where you could see it move the front end of the car. It was like the front end/whole car being tweaked and twisted a bit. I will say, I struggle to find good jacking points on MOST cars. The ones that have good points, I then normally struggle to find a jack tall enough to make the car change height!   One of my go to points for either the jack, or the axel stands though, is either a suspension pickup point, OR a subframe to chassis major bolting point. I actually think its the subframe on my R33 that has a bit of a bend in it, from being jacked in the middle too. However, it could have been one of my many other cars I've had over the years! Or it could also be the from me jacking it up, and the fact the top of the front radiator support isn't there, so it can allow the front of the car to move and bend etc.
    • GTSBoy
      M35 Aftermarket Fuel Pump

      By GTSBoy · Posted

      My apologies. I forgot we were talking about weird beard M series stuff. Had been talking elsewhere with someone about an R33 with similar subject and got confused.
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Nope, I don't like the look of ND RF, or any ND really, I don't like their faces or arses, why, because of their "modern" lines, the NC, whilst "modernish" has a more rounded shape that I like Well, that's how my overly judgemental eyes see it anyway  
    • Dose Pipe Sutututu
      M35 Aftermarket Fuel Pump

      By Dose Pipe Sutututu · Posted

      Should be more than fine, especially the overall fuel pressure would never exceed 3.5bar (assuming that thing never gets more than 0.5bar of boost in stock form). According to the chart, it's 11amps.
×
×
  • Create New...