Jump to content
SAU Community

Recommended Posts

gday guys recently had some probplems with my r32 ...it wil start and idle but idle wil slowly come down to a stall and if i try to rev it it wil hesitate something shocking al i can hear is air poping back through the pod filter .. and it wil rev to 4 grand and then just back fire as if rev limit was at 4grand any help please

check your afm and also youur O2 sensor...sorta had the same prob and i changed afm and it fixed it for a bit and then i scanned my car and it said the O2 sensor was buggerd so i just disconnected it and now it runs a dream..hope this helps.

  • 3 weeks later...

yo man this happened to me, what mods are you running on your car?. what you can do is, first clean afm like said above, then check coil packs for any cracks, then make sure all spark plugs are good, and have got the proper gapping.. If it still doesn’t work and if your car has a decent amount of mods, change the fuel pump..

i had the same problem a week or so back, where my car would hit 3.8k-4.2k and start back firing very loud and the car wouldn’t go, so i put a gtr fuel pump in and it fixed the problem so it could be a fuel pump issue

Good luck man

niran

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • That looks good, but I think you're going to need much beefier side skirts now.
    • They are daft and there's a reason it never caught on. Steering feel? We don't need no stinking steering feel!
    • I gotta pull you up on this. It's driving me crazy. A shutter is something that closes, like over a window or in a cmera. The word you want is shudder. That LSD is clearly f**ked. Take it to a diff shop and get it disassembled and examined by an expert. YOu might have plates welded together or something equally crazy.
    • Define "starting to fail". Wy not just rebuild them?
    • Check the Nistune doco. There are a few assumptions being made here that might not be valid. I will list the things that occur to me: Base map. Base map for what? Base map for Z32? Then the cranking pulse width is probably wrong for an RB25. The extra 500cc of capacity might well be enough to prevent it from catching. Base map for RB25? I don't think you can load one of those into a Z32. You have to just make the settings correct for an RB25 in the Z32 base map. That is either K or the TIM to get the pulsewidth right. Loom. You bought a loom for an RB. And you plugged it into a Z32 ECU. Did you make sure that any iwre differences were swapped. From memory, there's at least a couple. And as per the others, I would suggest making sure that the fuel pressure is correct while cranking and that the injectors are actually flowing as expected. They really must come out and go on the bench, unless you do find that you have messed up as per above points. I would also suggest watching in Nistune to make sure that everything is reading correctly. That the correct binary flags are raised at the right time (like the crank signal), that there's no stupid values in K or TIM. That you have not got mismatched firmware for the ECU and/or a wrong image loaded.
×
×
  • Create New...