Jump to content
SAU Community

Recommended Posts

Okay, I love bass. I never truly realized how much I did love it till I bought my Alpine Type R 12" sub. What I enjoy most is more the physical sensation of a powerful bass pushing my innards around, more than high dB or neighborhood waking "doof doof", but I suppose they all go hand in hand.

So I sold my last car, sound system and all, and I'm looking at making a really nice set up in my next car, but I don't really understand all the technical jargon.

I'm trying to find what I was looking at earlier, and can't find it anywhere now. Subwoofer's come with their own SLP(?), SLQ(?) ratings, something like that, and I have no idea what each means.

Anyway, if I come across them I'll post them here again.

In short though, for the best physical sensation from a sub I'm guessing you want a larger surface area more than anything? Like, two 15" subs will out perform a single 12" even if the 12" has a slightly higher RMS value than the two bigger combined?

Thanks guys.

Link to comment
https://www.sau.com.au/forums/topic/257500-subwoofer-basics/
Share on other sites

Normally subs will not come with a rating for what there better for however they are generally supplied with T/S paramaters (Theile / Small). From these specs you can normally work out what the sub is better suited too.

In the big scheme of things the RMS value of any speaker means very little and it is not something to use to compare different models with, the RMS value is just a thermal rating meaning sure the voice coil may be able to handle that amount of power but you would have far surpased the mechanical limits of the spider and surround before you get anywhere near that value.

The larger the surface area of the woofer(s) that you are using the better. Obveiously the bigger the moving surface / mass the louder and deeper it can play with less stress placed upon it.

There are alot of other factors to consider when looking at subs such as the Xmax, Fs, values.

Remember tho a sub is nothing without its enclosure,even a single 12" in a properly designed enclosure is enough to give your internals a good beating.

What subs are you currently looking at?

Jack

Edited by Jack88
Normally subs will not come with a rating for what there better for however they are generally supplied with T/S paramaters (Theile / Small). From these specs you can normally work out what the sub is better suited too.

In the big scheme of things the RMS value of any speaker means very little and it is not something to use to compare different models with, the RMS value is just a thermal rating meaning sure the voice coil may be able to handle that amount of power but you would have far surpased the mechanical limits of the spider and surround before you get anywhere near that value.

The larger the surface area of the woofer(s) that you are using the better. Obveiously the bigger the moving surface / mass the louder and deeper it can play with less stress placed upon it.

There are alot of other factors to consider when looking at subs such as the Xmax, Fs, values.

Remember tho a sub is nothing without its enclosure,even a single 12" in a properly designed enclosure is enough to give your internals a good beating.

What subs are you currently looking at?

Jack

Well, besides a bit of online research I only know what was around 8 months ago. Like I said I had a 12" Alpine type R (in an Alpine ported box designed for it), I loved it, but next time I want more.

I know nothing about 15" or 18", but I was considering a pair of 12's. From memory Fosgate, Kicker and Alpine Type X are the next level up. Like I said though, volume isn't such a big deal. Ideally I want very high quality sound, and a nice strong physical punch that you can really feel. I'm guessing that means a pair of quality 12's or a nice 15"? Both in sealed enclosures?

Saw this today;

http://cgi.ebay.com.au/soundstream-xxx-15-...%3A1|240%3A1318

Overkill? I know nothing about the brand, but it seems pretty cheap, so long as you can afford the amp and batteries to support it.

Thanks for the response.

Edit: Quick question; what size sub(s) can you fit in an R34 boot?

Edited by KezR33

soundstream 12s are apparently enough to make a R33 rattle, so i would say, yes that would be over kill for what you are looking for.

Kicker make some decent subs, i would probably look more towards the Alpine though. two 12s would be more then enough bass, if you power them correctly, OHM, WRMS, etc etc

Best bet, go to a audio specialist, listen and chat to them about it. They will help you out a fair bit.

Cheers,

FYI, two 12" will fit hidden behind the panels in a R34 GTT. in fiberglass boxes. I have 1 there now but room on both sides

two 15" will fit if you dont want a boot anymore same for 18, plus the car will self destruct from vibrations,, along with the all the birds in the trees and kids on bikes .lol

a well designed system is better then just generic parts tossed in and hope it sounds good. a single 10 can rip your head off if done right? ???

Im not a huge fan of 12's but for some reason oz had that as a standard rather then 10 or 15 ? along with the dreaded 6x9's.

yes I know jack88 my car has a 12 but only because its a left over from my old car....so dont start..lol

in the next incarnation its going to be a 10 or 2 digital design 8 inchers in a single reflex carbon fiber box. ported thru the rear deck

the higher the sensitivity in DB to start with the less power it will take to get loud, every 3 db is around 2 to 3 times the power level to increase the sound output

so a 89db woofer will need more power then a 91db woofer to reach 120db. but there is a lot of other things to consider. the box design, a sealed box isnt as the best but will control a woofer up to its tuned freq before distoration. and sounds smoother most of the time. at a lower cost to construct then a bandpass box.

so many varables to deal with for a pro system

rather then writing all this out for you, have a read here?

http://www.the12volt.com/caraudio/boxes.asp

if you need help just pm me. figure out your budget and if your a brand loyalist we can go from there ?

cheers

Troy

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes the gear for the R33/34 is different, it is red and has a different number of teeth. My part didn't come with that gear though, so I don't know how many teeth are on the red one. You'd have to reuse the 260RS/R33 gear, as long as it's not destroyed.   Haha, as unfortunate as that might be it was working fine for about the first 1500km I've had the car for now.
    • Update all   thanks to the workshop manual, it lead me back to checking fuses as mentioned central locking and door open lights worked when acc was switched on. diagram attached shows two points of power 1. ACC and 2.  Batt with the later being fused (#28) I did check the fuses using a multimeter but I must have stuffed that up also. Went back and checked the batt fuse in interior fuse box and you wouldn’t believe it… a blown fuse. replaced fuse and everything is now working as it should including the climate control   thank you all with your positive insight and knowledge.    
    • Where is the warning "That this thread is super old"   I just went into a 5 year old thread, went to do a reply, and couldn't see anywhere obvious a warning of it being super old
    • Duncan is correct. Pitwork (and Toyota's own cheap brand "Drive Joy") were primarily created as brands to sell other manufacturers car parts. It would be weird if Nissan sold parts for Toyota vehicles with a Nissan logo on it, so they created Pitwork to sell parts for other brans Toyota, Honda etc. They are not the same as Nissan genuine parts, although they *do* meet Nissan's standards for replacement parts. They aren't supposed to be a substitute for genuine parts, but a cheaper alternative that is better than Ebay fake parts from you-know-where.
    • Thanks GTSBoy, much easier to work with it now it's free!  
×
×
  • Create New...