Jump to content
SAU Community

Recommended Posts

hey guys,

easternats will be running from 10th to 13th of april.

would love to see a big turnout of skylines there, i filled in my entry form, but will send away

closer to the day, never know what could happen until then.

i will be cruising the tracks, drags, and im 50/50 on the burnout comp.

anyone else entering?

regards,

Baset.

Link to comment
https://www.sau.com.au/forums/topic/258153-easternats-2009/
Share on other sites

  • Replies 82
  • Created
  • Last Reply

Top Posters In This Topic

I hope the purple R33 that was drifting the front stright last year goes back. :blink: .

would that be [ZILA33], the gtr, if thats the one ur talkin about, no it wont be going back.

got full epa'd and now sits in workshop in pieces, as he thort it be funy idea to try tune it on...

...... 45psi. ARP head studs stretched.

so NO it wont be there. but his other car will. 5.7 ltr VYSS wagon. hopefully on the gigglegas

Link to comment
https://www.sau.com.au/forums/topic/258153-easternats-2009/#findComment-4440047
Share on other sites

  • 3 weeks later...
would that be [ZILA33], the gtr, if thats the one ur talkin about, no it wont be going back.

got full epa'd and now sits in workshop in pieces, as he thort it be funy idea to try tune it on...

...... 45psi. ARP head studs stretched.

so NO it wont be there. but his other car will. 5.7 ltr VYSS wagon. hopefully on the gigglegas

seen and heard that .... its scares the shit out of my wagon lol

Link to comment
https://www.sau.com.au/forums/topic/258153-easternats-2009/#findComment-4483072
Share on other sites

That gtr was carzy tuff got a nice vid of him last year entering the track from the pits, crazy 4 wheel smoking take off.. hehehe

will be up there car will not be with me..

link to vid??

just found out his going 26/30.. so next year should be good:)

Link to comment
https://www.sau.com.au/forums/topic/258153-easternats-2009/#findComment-4500286
Share on other sites

yea i be going to easternats doing the ride around the track do i have to fill out a form to go on the track or just the drag and burnout comps??? getting my car prep this week end for it new rear suspension going in next week and doing brakes and general service if i have enough cash maybe get a tune as well :)

Link to comment
https://www.sau.com.au/forums/topic/258153-easternats-2009/#findComment-4513203
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Well, yes, every CU on the bus is available via the Consult port, but whether the scanner you are using is capable of talking to the TCU, the ABS/TCS modules, etc etc, is what is at question here. Many of them are only for engine codes. So, if you have one of those, you won't know if the ABS is having a bitch.
    • That's now. R chassis Skylines come from a time when the tolerance in the ADRs was a bit more....slack. My car, on 235/35-17, which is damn near the exact same size as the original 205/55-16, is pretty much bang on correct indicated speed across the whole legal range. That's demonstrated with constant speed run over 5km, and GPS speed. It's just the luck of the draw. My particular speedo head has to be the thing that is "calibrated" that way, because everything else (the diff ratio, the gearbox and the speedo drive**) are all same same as most other Skylines. **OK, so the speedo drive is a Navara unit to drive the R32's cable, not the electronic unit than an R33/4 would normally have with teh same gear on it. Otherwise, I applaud your OCD tendencies, and I would do the same if I needed to.
    • Not too sure, I believe the Nissan consult port does everything? Also just filled up the reservoir to full and the light is still on. The float seems to move up and down fine.
    • The speedo's can be very conservative, when my Mazda NC MX5 speedo is showing 118kph, the GPS, and a calibrated radar.... cop mate.....hits me at around 110kph +/- 1 or 2 kph, and that is on a 215/45 17, stock tyres size is 205/45 17 as well, so weirdly conservative with stock tyre size When my Commodore speedo red 116kph GPS had me at 110kph on 255/40 17, so again conservative Google says manufacturers need to set the speedo from 4 to 10% slower than actual road speed.....for safety.....and compliance  After doing some offset and clearance measurements to see what can fit the NC on 17x8 +40, without guard rolling or rubbing anything at my current ride height, I've decided that when my tyres are toast, I'm going to fit 225/45 17 and see where that gets me IRT actual speed of my speedo and GPS/radar From the online calculator I should be still be doing around 5kph under an actual 110kph when the speedo is showing 110kph My ADHD requires that when I'm doing 110kph on the speedo, that the actual road speed is actually really close to that, and not alot slower And going from 205 to 225 still keeps the car within the %/mm allowable in the NSW vehicle rules and regulations, which is nice, as long as I'm looking at the latest version that is.....LOL https://www.nsw.gov.au/sites/default/files/2021-02/RMS-13.464-Light-vehicle-modifications-Vehicle-Standards-Information-No-6-November-2013.pdf
    • Take the value it measured as, and pick the closest range available that is above the reading on the screen.   Also, no point just testing the coils. Read what has been said again. You need to test all your wiring, everything.
×
×
  • Create New...