Jump to content
SAU Community

Recommended Posts

Thanks for that. Yes i rang him and had a "good LONG chat" ... He's a very nice guy and knows his stuff.He really took the time to run through ALL the options with me.Looks like I'm going to use a stock flywheel and he's going to build a single plate carbonic? as my mrs is the prime suspect in the demise of the nismo twin (no slip).

thanks again.

Link to comment
https://www.sau.com.au/forums/topic/258502-jim-berrys-no/#findComment-4445709
Share on other sites

  • 2 weeks later...
I wouldn't.

have a look around at people who've used 'upgraded' jim berry clutches with stock flywheels. search for "benm"s threads for a start...

i looked at thread with his car pics on it, and yeah, lightened stock flywheel cracked & went thru his bonnet and cut his front pipe & rail in half, but if you're using a stock flywheel that hasn't been lightened it should be alright ?

Link to comment
https://www.sau.com.au/forums/topic/258502-jim-berrys-no/#findComment-4485231
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...