Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

in for pg 700.

*1400

Now taking guesses as to how unfit I am. In between this post:

F*ck door trims.

For a show and shine winner, my car is an utter shitbox :(

And this post:

</3

I went for a 20min ride, and am completely f*cked. How far do you think I went?

Winner will receive 1 broken door trim clip, and possibly some abuse.

Edited by Smity42
I went for a 20min ride, and am completely f*cked. How far do you think I went?

Winner will receive 1 broken door trim clip, and possibly some abuse.

*treading carefully*

10k's?

20 minutes, you probably rode to the park near the paper mill.

Anna its your fault he won.

Martin i can repair this door card.

*treading carefully*

10k's?

You sir, give me too much credit.

20 minutes, you probably rode to the park near the paper mill.

And you don't give me enough :(

Anna its your fault he won.

Truth.

Martin i can repair this door card.

I'll hold you to that.

Passenger side I think is just about sussed. Doesn't seem to clip perfectly in the corner but its pretty good.

Driver's side I'm waiting for glue to dry on the two mounts I crimmed from my new spare trims. Will see how it holds up after that...

Morning Mangs,

How do you do skids in a boat? :D

Jokes mang, congrats.

should try owning a stagea if you think an r33 is a boat :)

2T with fuel and driver .. even boats arent that heavy :)

Edited by PetroDola

Morning Mangs,

Driver's side door trim is now holding on about as good as the passenger one. Not perfect, but at least the trims don't fall off as you open the door any more :).

post-46752-1289388652_thumb.jpg

post-46752-1289388666_thumb.jpg

that is all

approved-stamp.gif

:D

That's what she said.

Holy mother of god!

That's what she said.

should try owning a stagea if you think an r33 is a boat ;)

2T with fuel and driver .. even boats arent that heavy :)

My coon weighs a slightly less than that. Want to trade? ;)

10k's?

No Dice, Too high.

20 minutes, you probably rode to the park near the paper mill.

= ~3km round trip. No Dice, Too low.

3.6km Martin.

Still too low. Just think how far I could have gone if you hadn't run me down and busted my knee...

Supercheap... or the equivalent distance in any other direction.

Assuming you mean super cheap at lawnton... = 6.0km round trip. Oh my, this is going down to the wire...

6.3km
6.31km

I needed to refer to the cyclocomputer to resolve this one, I knew it was 6km but going to two decimal places, sheesh!

and the winner is...

...

...

...

...

6.08km!!!!!! It's JOHN!!!!!!!

Congratulations, you useless dole bludging bastard (right, thats the abuse coverred). You may collect your broken door trim clip tonight.

Edited by Smity42

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Yea got me coppers. Bad news is I just put them in and the car still has the light and shakes. I also noticed I hear like rattling coming from the exhaust piping right under me. Does 21 also have a possibility of being O2 sensors?   So, coil packs are good, the harness is good, the MAF is working, and obviously the spark plugs just replaced and working.
    • Make sure you drop the GTT base tune back in, and set your injectors again, this will remove anything playing up with it you may have removed. Possibly lean there as it's normally a fast transient going THROUGH atmospheric pressure, and a turbo motor would then quickly go richer as boost builds. The only worry you MIGHT have is ignition timing, as the DE is higher compression than the DET from memory. But again, you're not in boost, so the DE motor will be a lot more forgiving at atmospheric.   Get Murray, Kinkstahs, and Johnny's input on tuning haltechs, those guys have played with tuning enough in the past to be able to help now you're past the trouble shooting stage of the MAP issue
    • @Rusty NutshI mate. Do you have a pinout diagram for the na neo auto ecu? 
    • Yeah thats the plan now. 🤞
    • Have a chat with the tuner, you'd want to drive the car straight there.
×
×
  • Create New...