Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

Morning Mangs,

Site managers first day on holidays so I've spent the first 2 hours photoshopping random pictures for the site foreman lol. I should probably do some work though...maybe.

Morning Fellows! Hows it all going? Hopefully chucking the new brakes on my car on Saturday or Sunday, been ages since i have done any spanner work. Looking forward to it! Even if it is an easy job lol

Mangs,

Sitting at Motor One waiting for them to tint a craptiva. It's a good break from how busy it's been today + the heat :thumbsup:

*waves out the window at Dan*

Well dont we have a cushy job :rolleyes:

I do

I rekon i do to as am at work and bored so reading SAU. And my boss doesnt give a f today either so great day.

So... anyone want to buy a new car :whistling:

Mangs

Playing COD

Busy day, so will get back to it.

As you were

WTF I pressurised my intake system again... all my piping seems fine. It seems like there's an air leak somewhere around the rear of the motor, on the turbo side, kind of around the back corner of the rocker cover. One of the screws there was half a turn loose so tightened that but realllllllly doubt that was the problem. I already packed up the compressor etc so I didn't check again but I doubt it did anything.

What other pipes run around the back of the motor that carry pressurised intake air??

Anyone have any opinions on this?

I rekon i do to as am at work and bored so reading SAU. And my boss doesnt give a f today either so great day.

So... anyone want to buy a new car :whistling:

Yes I do

But I am looking at a BMW 535i, So if you have one of those it would be great!

Yes I do

But I am looking at a BMW 535i, So if you have one of those it would be great!

well if you look at the cars i sell front on and they are in silhoutte then we would be close

Anyone have any opinions on this?

It's F*cked.

:P

Sorry, pretty hard to have a guess at what's wrong over the interwebs.

The only hose that carries air towards the back of the motor should be the feed for the idle control motor... can't remember if this is pressurised or not, I think it comes of the J pipe though so I would guess yes.

My money is still on exhaust leak before the turbo or wastegate stuck open.

Andy,

Our garage is empty enough now, if you want to start to use your garage for your car instead of storage.

Andy,

Our garage is empty enough now, if you want to start to use your garage for your car instead of storage.

Cool, You around on saturday? Might get it towed then? PM me your adress and I will start ringing towies!

I thought wastegate stuck open as well. But then again I don't have a big idea of this sorta thing.

Just realised new sau layout is mobile friendly. Yay.

Anyone have any opinions on this?

Tappet cover gaskets will leak like a bitch when thos screws get loose (Which they always are) Tighten all the screws and go from there. My R33 has lots of leaks from that area and when i fixed it all up the car was much better behaved, Of course your gasket may be rooted too but try tightening everything first

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
    • Yeah - I mean, go the other way. Smaller range. Not larger.
×
×
  • Create New...