Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

how much killer wasps does a supercharged bug motor make?

It varies a lot. Depends on how much you change the compression & timing and what charger/inlet/exhaust etc. Seen a couple close to the 150HP mark though.

Edited by Isola

All of which (especially the jetski) are water cooled? :P

arhhh yes, i now see your point... very true...

although im not sure about the Lexus, when you pop the hood all i see is a massive plastic cover...

so who knows whats going on under there, probably a big Japanese mouse on a wheel...?

how much killer wasps does a supercharged bug motor make?

also, you didn't tell me you were paying :P

also, there are laws that prevent that engine fitting.

Now you're just getting carried away :P

slight difference in air temperature/volume/density that cools that one :P

its a 41L just a lazy 2500 cubes lol

that will fit yeah?

That's bigger than the car!

The combined bore sizes are bigger than the length of the car ffs!

So? The point is that 150HP is not enough. And being air cooled is no excuse :P

Isn't that the one that caused most of the b29's to crash and explode in flames?

Probably. They should have used a Merlin.

So? The point is that 150HP is not enough. And being air cooled is no excuse :P

Probably. They should have used a Merlin.

It's plenty enough for a car and engine that size.

You wanna buy me a Porsche engine and pay for the conversion and mod plating, be my guest. Otherwise, direct bolt in FTW :P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...