Jump to content
SAU Community

Recommended Posts

i just bought a R33 GTST for drifting and dont need many parts from it so here is a list:-

Power FC with hand set 1 week old - $1300 ( going Autronic )

GCG 500hp Ball bearing turbo - $1000 ( std casing RB25 high flow )

New stainless manifold to suit turbo - $300

Full 3" exhaust with dump pipe - $350

600 x 300 x 76mm intercooler kit - $ 300

complete interia minus seats and dash - $ 350

fuel tank with aftermarket pump - $ 200 ( dont know what pump it is but guy said it was a 600hp capable)

bonnet - $ 200

Pm or call me on 0433002228

no sorry, just some shity aftermarket one... free is some one wants it...

also update :-

Power FC sold pending payment - but handset still avalible for $200

Turbo sold pending payment

  • 2 weeks later...
  • 4 weeks later...

I really need the tracking number for the hand controller which I purchased from you off some time ago now. It still hasnt arrived and we need to find out whats going on.

Please get back to me with the tracking number as you said you would previously when I called you.

Cheers.

I really need the tracking number for the hand controller which I purchased from you off some time ago now. It still hasnt arrived and we need to find out whats going on.

Please get back to me with the tracking number as you said you would previously when I called you.

Cheers.

Performance_wise, do you sense you're being ignored ? hmmmmmm smells like a un-bathed chick's inner thighs.....

Why dont you ring him on his posted phone number - 0433002228 ?

Edited by smok74
Performance_wise, do you sense you're being ignored ? hmmmmmm smells like a un-bathed chick's inner thighs.....

Why dont you ring him on his posted phone number - 0433002228 ?

It is a bit pongy but I'll give him the benefit of the doubt. I spoke to him on that number a week or so ago and he said hed get back to me.....must b too busy.

Ive txt him, emailed him and PM'd him so he must know Im here :D

I'll try callin again tomorrow. (if I get time).

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Didnt realise RB's had more then 1 head.
    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...