Jump to content
SAU Community

Recommended Posts

SR20 red top, suit rebuild. Loom included. One of the coilpacks, cas, oil pump and sump is broken. Will supply brand new oil scavenger. Turbo OK. $500

Located Mt Gambier, SA. Can organise free freight to Adelaide, other locations buyer pays. Call 0435 281 536. Don't expect prompt replies if you PM or SMS.

post-18999-1237859169_thumb.jpgpost-18999-1237859319_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/262452-sr20-red-top/
Share on other sites

so apart from the coilpack, cas, oil pump and sump, is there anything else wrong with it? whats it been in a crash?

will new parts bolt back on or will it be interesting lol

Oil pump died and the car sat idling for about 30/45 min before I realised. Drove it home about 70kms and was fine, no noise from bearings and boosted fine but I changed it with another red top that was lying around at a mate's workshop. Then the engine sat around for a while out of the car and water got into the valley and ruined a coilpack. CAS was swapped out and sump was damaged in the container on the way home from Japan.

Nothing else wrong with it as far as I know. New cas, coilpacks, oil pump, 5 min with a hammer on the sump and you'd probably have a good SR20 for cheap, but then again the bearings might be shot, cams scorched, etc..... who knows, hence the cheap cheap price. The fact that it ran fine afterwards says that it probably isn't all that damaged.

Link to comment
https://www.sau.com.au/forums/topic/262452-sr20-red-top/#findComment-4495575
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • @GTSBoy Ok so that was the shops problem...they showed R33 rotors on R34 page and i did not know 296 do not fit(and are for R33) Yes i bought "kit" with rotors and pads. Pads are ok(i have GTT calipers front and rear). They have some 324mm but no 310mm. So i dont know if they would fit. I have 17inch LMGT4s So another question. Can i fit those in the rear or they are just "too" big for that?
    • I started removing the tank a while back with the intent to give it a proper clean. Got to a bolt that I couldn't undo completely due to a diff being in the way, so just said f**k it and siphoned the gluggy old fuel out and called it a day. Looking it the tank it looks less corroded than the one in the pics for that billet hanger from Frenchy's anyway. Isn't it the fuel filters job to worry about this stuff? I scraped off most the crusty shit of the hanger but will give it another go before reinstall coz maybe the fuel and return pipes are also full of gunk  
    • Pretty sure it is a common fault. I believe this is the only part you need, but don't quote me as I don't have a V36.  I also believe it is a bit of a pain to change and the device needs to be encoded to the car once it is replaced, so may need someone with the right tools. Buy Genuine Nissan 48700JF00D (48700-JF00D) Lock Set-Steering. Prices, fast shipping, photos, weight - Amayama
    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
×
×
  • Create New...