Jump to content
SAU Community

Recommended Posts

Hi just wondering if anyone knows how to adjust the ride height on the isc n1's? is it hard and if anyone has done it before wud they mind helping me do it wen ever? and also how do you stiffen them up?

i heard there is tools that come with them but i cant find them any where.. where could i get them?

Thanks.. really wana get my ride lower!!! :unsure:

Link to comment
https://www.sau.com.au/forums/topic/264970-adjusting-isc-n1-coilovers/
Share on other sites

The spring sits on height adjustment rings just like any other adjustable coilover. Wind them down to lower it, using a C spanner. Easy.

Just remember;

- you'll need to get it aligned again if you change the height

- if you want to do it properly you should get it corner weighted

- if you lower it too much you'll have to get aftermarket adjustable bushed/arms to be able get the alignment right

- if you lower it too much it will handle like crap

yup...

1 measure how much you want to drop by (to the mm)

2 take wheels off

3 on the top there should be 2 adjusters... get a measuring tape and work out how much lower you want it... to the mm

4 drop the bottom one to the desired height and then move the top one down till they touch

5 then tighten by turning in opposite directions

6 put wheel on

7 swear and whinge when you realise its not quite right

8 repeat steps 1-6

9 check for scrubbing

10 roll guards / remove guard lining if req'd

-ISC Coilovers are base height adjustable, please do NOT lower the coilover primarily via the spring seat.

-To stiffen the coilovers you adjust the damper via the top of the strut with the tools provided (If purchased new the tools will be in a small bag with the coilovers, make sure you havn't discarded them along with the bubble wrap etc).

Ryan

Edited by ISC-Performance

Loosen the clip above the bottom bracket with the c-spanner and then wind the bracket up or down accordingly. If you purchased the coilovers second hand etc and you dont have a tool pack you can purchase one through us at ISC.

Ryan

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...