Jump to content
SAU Community

Recommended Posts

  • Replies 108
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

with flux compasiter modz it also allows time travel :P the 88 miles is just bs i tell you, 4wd luanch with 275wide tryes is how its done

this thread is so wasteland now :P you dirty bsterds turning what was a clean thread about pics of chicks on cars

good point dan, to return this thread to topic...

heres a chick;

Megan-Fox.jpg

and heres a car;

ac_schnitzer_bmw_m3.jpg

and while the awd limiter launch might start out all good, what happens when you say the words; "im an accountant."?

hell, im not saying id knock her back (if anyone does, you might wanna reconsider actually living your life)... ive forgotten my point...

well no, but why ruin perfection with the pathetic scribbles of a fat biker dude with a needle and ink... why god why? women are (generally) beautiful as it is - they dont need inks.

I guess its because my dad was a bikie at one stage and most of the disgusting trollops that hung around them were butch, unladylike heathens who were heavily tattooed and smelt worse than a boiled sheeps spleen... bikie moles... *shudder* need I say more?

-D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • lol the 2nd one boss, thank you for pointing this out. I feel as i spend more time here this intro message is some thing i will always make me laugh and shake my head at. Perfect Intro:  I have the vehicle  
    • R34DE as in R34 with an RB25DE? So did you get this? Or you planning to?  I'm not really sure what you're saying. 
    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
×
×
  • Create New...