Jump to content
SAU Community

Recommended Posts

I think you would be more than lucky if there isnt ceramic dust inside the motor...

But anyway, you cant really tell @ idle. Obviously power/boost wont be the same... thats a given, but then why even attempt that and almost gaurantee a dead motor.

Just pull the dump off

well you have two turbos too worry about. but if it's stock then that seems reasonable. what give you the incline that they were damaged or were you just asking for future reference?

when it happens you will know about it. if you have the cash get some steel wheels put in there or upgrade. my 2c.

Symptoms are: no ability to make boost, and crappy running if you run the motor under the conditions in which it would have made boost. The working turbo will just push air backwards through the broken turbo's compressor, therefore no boost at the plenum. Idle and low throttle are fine as you are in vacuum.

just put some steal wheel turbos on a mates gtr he was on his way to adelaide and was all fine then went to over take a car and no boost, there was no bang clunk or anything just fell off. replaced turbos and checked comp and all good.

so they can let go at anytime you dont need to be giving it a hard time at all. we also never found the wheel thanks to a decat pipe.

From what i have gathered you dont have to be boosting hard thus creating massive heat and spinning the turbos at 1000000rpm for them to let go.

I guess with age, the more shaft play u get, if the exh wheel only scrapes or bites the housing this would be enough to send it flying out the back!?! That's why it's more common with the r32?!?

Its predominately heat, heat generated by shaft speed IMO.

Which is too much boost in the given application in simple terms.

eg. You are probably OK with 13-14psi for usual street duties

Circuit you wouldnt run anymore than 11-12psi... being extended laps is going to get a lot more heat in there

Hence its usually the rear turbo that lets go - hottest cyclinders are 5/6 in a stocker style setup.

Hence its usually the rear turbo that lets go - hottest cyclinders are 5/6 in a stocker style setup.

Why do 5/6 get hotter? Is that why ppl richen up 6? Or does 6 run a little leaner than the others so its just compensating?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Let large companies that are making money off selling kits do the preliminary engineering for you. If they all do -10, then that is all you'll ever need. 
    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
×
×
  • Create New...