Jump to content
SAU Community

Recommended Posts

hey skylineakt do u mean like the vents the R34 GTR Vspec II's have?? Just a triangle cut-out of the bonnet, with some mesh, above the air filter? I'm pretty sure only VSpec II 34, GTR's have them.

Guest RedLineGTR

just take a bonnet off....and you dont have to pay for anything...100% ventilation. The bonnets with scoops and vents are all the carbon fiber ones well most have aftermarket venting usally about 2-3 vents. Only r34gtrs the top version have a single vent as mentioned above which aids in abit of cooling around the turbo area.

Yeah that looks sweet!!

Even with our Blk Skyline it would still looks good!! hehe

See the scoop/cut on the right hand side above the air filter??

That's what I'm talking about.

Is it possible to have that cut in and mended without changing the whole bonnet??

Guest RedLineGTR

if u were realyl good at cuttin metal etc u would have to talk to a body kit shop. Personally i rekon it could be done. Cut the hole, file/sand.etc to its smooth around the edges. Or cut it in some way that u can bend the excess metal inside. Get some kind of mesh and something underneath to catch any water or something. But it would be abit of mucking around.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Just a thought, was that car and auto at any point of its life? If so, maybe whoever bridged the inhibitor switch/circuit did a not so good job.
    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
×
×
  • Create New...