Jump to content
SAU Community

Recommended Posts

hey guys just need some hinter's or somethin, ive noticed till just recently in the last few days that the car has eaten almost half a tank and ive only gotten 150k's out of her rather then the usual 200 odd k's any idea's? and yes ive tried to drive as economic as i can but even when ive put my foot down, i still use to get good mileage out of the tank so im just woundering what it could be it is due for a service soon so im just hoping that its just that and only that. that the oil is dirty or something.

first check for any fuel leaks as above as thats cost free

how does the car idle? if its idling like shit you might have a leaking injector o-ring spitting too much fuel in (pretty unlikely if no one has played around with them)

if that fails, replace oxygen sensor

Edited by snozzle

Have you got any aftermarket stuff on your car??

If so, the stock ecu might be having a bit of a hissyfit and could rich & retarding the tune/engine. In which case, you'll be constantly running rich, even when driving midly and hence you'll be using lots of fuel. Alternatively, your O2 sensor might have gone bad and might be malfuctioning. Considering Skylines now are 10+ years old, id could be a factor worth considering. As mentioned above, best taking first for a service with a diagnostics and tune. That way, you've got all bases covered. :teehee:

Have you got any aftermarket stuff on your car??

If so, the stock ecu might be having a bit of a hissyfit and could rich & retarding the tune/engine. In which case, you'll be constantly running rich, even when driving midly and hence you'll be using lots of fuel. Alternatively, your O2 sensor might have gone bad and might be malfuctioning. Considering Skylines now are 10+ years old, id could be a factor worth considering. As mentioned above, best taking first for a service with a diagnostics and tune. That way, you've got all bases covered. :blush:

cheers guys for the advise, its pretty stock, only mod is cat back, and errr.... it idles just fine, but odly enough the fuel meter sat at half way till it hit 200k's anyways, which is normal for my car dunno about others... so i may just be immagining things ><" but yea ill still go for a full service an diagnostics an tune thingy... ^^ its just hit 106thou k's so its due for one of those major service's so guess ill be needing to do that ^^

Edited by Sneakyazn
I would suspect o2 sensor failure. (or just worn out)

NGK do a replacement for around 40 or 50 bucks.

Its a cheap fix.

Hey Brad, can that be bought at repco or something, I think I might change mine while I'm at it... I've been a bit sceptical about my own fuel usage in recent months.. $50 isn't alot of money to part with for some certainty...

Yeh, get an O2 sensor, they usually go. And will hamper your cruising fuel economy. I have a R32 with RB25 putting out 219rwhp with WOLF 3D tuned. I got 609 km out of a full tank (60L). Which was city driving, highway driving, hard boosting on a car cruise and some stick for fun.

Otherwise fuel leak is probable, but you will probably smell petrol if there is a leak.

Hey Brad, can that be bought at repco or something, I think I might change mine while I'm at it... I've been a bit sceptical about my own fuel usage in recent months.. $50 isn't alot of money to part with for some certainty...

Should have. If not, let me know and i can arrange it for you through my work.

new O2 sensor and u should maybe look at putting a injector cleaning additive in the fuel have heard of this helping. also change your spark plugs. also clean ABV and AMF.

a major service's should be the ticket "Sneakyazn"

ABV and AMF?

ABV = air bypass valve

AMF i meant AFM soz = air flow meter

ABV is cleaned with brake cleaner and cotton buds

AFM is cleaned with AFM cleaner $25 it can be found at any automotive shop

anyone know if high flowed injectors will have worse fuel economy than the sards/nismos injectors .have a set of sr20's high flowed to 600cc and chewing through the fuel. got carbon all over the rear bar and my tuner is trying to tell me its the injectors bad spry patttern, not the tune?

ABV = air bypass valve

AMF i meant AFM soz = air flow meter

ABV is cleaned with brake cleaner and cotton buds

AFM is cleaned with AFM cleaner $25 it can be found at any automotive shop

Oh by ABV you mean the Auxilary Air Control valve and the Idle Air Control valve..

pull the injectors out and sonic bath them, we do them at rotomotion, bring them in, we can tell u how good the spray pattern is

So you work at Rotomotion hey Harry.. I have a set of 1000cc injectors there to be flowtested :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Welcome to my 2004 Toyota Mark ii IR-V Fortuna (series 2) With a 1JZ-GTE powerplant under the bonnet (hood) it'll give me plenty of scope for power upgrades. For those who aren't familiar with imports, the 1JZ-GTE is a 2.5L 6 cylinder VVTi engine with a single turbocharger. This has the factory R154 5 speed gearbox, along with a aftermarket 2 way LSD differential (brand unknown). Under the arches are a set of CST Zero 1 alloys, 18x9 +30 225/40 up front and 18x9.5 +15 265/35 on the rear. The car was quite low in Japan and there's evidence of the wheels catching the rolled arches/fenders. The tyre's aren't great so I'm in two minds whether to replace both or just the tyres and put up with the wider wheels on the rear. The car still uses stock brakes with the addition of some braided hoses. The exterior is stock with the exception of a BN Sports front bumper and a replacement Fortuna grill  Moving to the interior, the steering wheel has been replaced with a dished MOMO steering wheel (which will get swapped for my Momo Tuner for the time being) Defi Link Gauges are mounted above the climate controls and on the A pillar, the Oil Temp,Oil Pressure,Water Temp and Boost gauges should help with spirited and track driving  The stock seats have been replaced with some retrimmed Recaro bucket seats. Being a larger build these are a little snug, unfortunately the orange isn't for me so I'll look into replacing these down the line. Other modifications include a twin plate clutch, Blitz intercooler, Evolve alloy radiator, a stainless exhaust with decat, HKS EVC-S boost controller and coil overs
    • Apologies for the long read My R34 GTT was up for sale at the beginning of spring due to a few repairs creeping up. The strut tops needed replacing, roof and bonnet (hood) painting (yay for 3 stage pearl) and the underside stripped and treated. I sold the car which allowed me to be in a much better place financially. Leading up to the sale I was already thinking about the replacement. In an ideal world it needed to be a good all-rounder. Something I can mess around with, modify, do track days, do the school run, go on long drives etc.  Options included but not limited to... Laurel C35, Evo 8/9, Civic FD2, Impreza Hawkeye, Aristo and even an Audi S4 Avant (I've already got the Mazda 6 wagon). But there was always one car at the top of the list The Toyota Mark ii JZX110 I found an advert on a Facebook group for an example in Japan, from a seller called Jon at Rising Sun Exports. A few messages back and forth and Jon calls me from Yokohama one morning (or afternoon in his case). He briefly explained the import process, the costs involved and a repeat of the advert. After much deliberation, the price was agreed and the sale was locked in. I've never imported a vehicle so I jumped into the unknown head first. The money transfer was completed through wise.com (fees apply), very easy to use and the money was with him within a day or two.  The car suspension was raised for the vessel and the car dropped off at the port. It was 7 weeks later when the bill of lading was received and the freight invoice sent to me, followed by the export certificate a couple of days after (both digital copies) In the mean time the port had been in contact. I needed an agent to deal with the NOVA (notification of vehicle arrival) along with the tax/duty invoice, this was £75.00. The port also had a fee of £100, I'm guessing to cover the cost of the 10 day 'free storage' and for moving the car off the boat etc. They need a copy of the vehicle invoice, freight invoice and export certificate to allow the vehicle to pass through customs. The vessel arrived on Tuesday 5th August, the tax/duty invoice was generated and sent over. This is generally tax 20% and duty 10% of the vehicle value. Although the invoice came in at a higher amount than I had calculated. Once HMRC had received the payment the vehicle could be released from customs. I thought once the tax/duty was paid you could collect at any point, that's not the case. Your agent will need to book a collection slot, I requested Thursday 7th which was accepted, with a 9:00am slot allocated. It was a 5:00am start from Norfolk heading to Southampton. We eventually found the compound, upon presenting the bill of lading and some ID they released the car (they drove it out of the compound to the front ready for us to load up). The email from the port stated each slot had a 10 minute window, which seemed abit farfetched but the staff said it's not a strict rule. We were there for approx. 30-40 mins in total. A week prior to collecting I contacted my garage and explained the situation, I was able to get an inspection slot that afternoon. For the registration, DVLA require the car to be insured, for this I used a company called Adrian Flux who can insure the vehicle using the VIN number. 
    • Hey guys, looking for these side skirts if anyone can help me out. 
    • Wife and I are still looking for a new home. One condition was a large enough garage for a full-size lift in one bay. Now if only we could find something... We've been looking for almost a year now.
    • Thanks everyone for the ideas! Sadly, ramps are a no go for me. With young kids at home, I do most of my work late at night while they're sleeping. Starting the car multiple times wouldn't be a great idea.  I'll go see one of those new long reach low profile jacks and take a couple measurements to see if they will fit.   
×
×
  • Create New...