Jump to content
SAU Community

Recommended Posts

I went there to have a look, not as busy coz its 1st day..

Couple of SKY i saw there, 33gtr (12+ sec) and 34gtt (14+)

i was there also, i think that it was quiet due to the chance of rain

i didn't see the 33 GTR there but saw the 14 second 34

I go every week and watch as i work acouple of mins down the road. The 33gtr seem to have some issues with traction running a 12.8 but it looked like with a good 60ft it would have no problems being able to do a low 12.

Hope to see some more skylines down over the next few weeks.. :woot:

I go every week and watch as i work acouple of mins down the road. The 33gtr seem to have some issues with traction running a 12.8 but it looked like with a good 60ft it would have no problems being able to do a low 12.

Hope to see some more skylines down over the next few weeks.. :)

hey i saw your car down there last week looked mint

it was your car at wa suspensions a few months back where we changed the steering rack wasn't it

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • How would you even adjust the clutch if the pedal already has the correct free play? The operating cylinder has no adjustment in mounting position or rod length. On pull style clutches there is also no ability to adjust the bearing carrier. Push type I can see how adjusting the carrier height makes it all work.   If this is the twin plate clutch did you verify that your friction disks were oriented correctly? It's not mentioned in the directions at all you just have to notice that one side the friction disks have a part number on the hub fingers and a subtle coning to those fingers. Another thing that I noticed was if you put the friction disks in backwards the pressure plate fingers will not be even and flat when the clutch is installed.
    • yeah, mechanically, it is probably do-able, off the top of my head, there would be the transfer case, which I believe will bolt up to the rear of the RWD transmission, the shorter rear tail shaft. A front drive shaft, front diff, engine upper sump, front drive shafts, front hubs and front AWD struts (they are shaped around the front drive shafts), LCAs (at the very least from the front suspension) oil cooler.  You might want the rear diff from an AWD too, so you can be certain the front and rear diff rations are identical.  Who knows what brackets and mounts you might need.  So a whole doner car might be the best option if you need to maintain RHD. Then actually making it work, that would be a whole different story.
    • Take the fall as a warning sign for future endeavours  Stay safe mate
    • hi mate, HKS cooler piping still available by any chance?
×
×
  • Create New...