Jump to content
SAU Community

Recommended Posts

Yep 125kw/tonne is the legal limit. 32 GTR?? just a "tad" over :D

R33 GTS-T - 187kw, 1380kg.

135kw/tonne - illegal.

But it seems to be a bit of an unknown entity tho, as there are HEAPS of P platers driving over-powered cars but the coppers sometimes care, sometimes don't care.

I was going to get a R34 GT-T and take my chances (19) and most prob still be on my P's when i get one, so i'm not going to worry about it too much. R32 GTR is tempting, but i think u have to draw the line somewhere.

cheers.

yeh i got an R34 GTR, that i cannot drive on the roads anymore. First it wasnt on a list of high powered vehicles so they didnt know if it was too powerful and all. But, knowing my luck i got pulled over by one of those head of the traffic dept cops and he went and researched on the vehicle added to the list rang me up saying that i cant drive it and if i did i would lose my 2 license for 2 years, i dont know if he was bullsh**tin or not, but i dont wanna risk that..So it just sits in the garage and goes from dragz to dragz mostly...Got another 2 years left :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...