Jump to content
SAU Community

Recommended Posts

Dont go posting about turning up and taking money/parts, one he could read it and know whats coming and two it can be used in evidence to some degree, dont know if it would hold up in court but it wouldnt be helping your case if you were accused of any thing.

cheers

elliot

Link to comment
https://www.sau.com.au/forums/topic/286755-rb-2530/page/3/#findComment-4945723
Share on other sites

  • Replies 42
  • Created
  • Last Reply

Top Posters In This Topic

His name is Raymond Daley and his from Kingaroy in QLD. Im from Melbourne. I transfer $1920 into his account and still not have received my motor or my money back (its been a month). I try calling him and he pretends to be someone else. I contacted the Fed police but they are too slow.

PLZ HELP ME ANYONE. THIS GUY HAS RIPPED ME OFF $2000!

Well you blindly EFT money, this is what happens.

Sadly no-one can hlep you aside from the Police, good luck as they will tell you a similar story.

Dont go posting about turning up and taking money/parts, one he could read it and know whats coming and two it can be used in evidence to some degree, dont know if it would hold up in court but it wouldnt be helping your case if you were accused of any thing.

cheers

elliot

Excactly, but if someone blindly EFT's money to someone then clearly they are perhaps lacking in the thought department :)

Either way, thread closed.

In future, please use your bl00dy brain when buying over the internet.

Feel free to PM me the account/address information and i will add to the bad trader listing.

That is all.

Thanks

Link to comment
https://www.sau.com.au/forums/topic/286755-rb-2530/page/3/#findComment-4945819
Share on other sites

Guest
This topic is now closed to further replies.



  • Latest Posts

    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
×
×
  • Create New...