Jump to content
SAU Community

Recommended Posts

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

Got the call today to say that Geoservices were pleased with my test results and said my interview was great!

I was offered a job on the spot and start as early as Monday :) sooooooo stoked and soooooo much more money then what I used to earn. Double infact!!

Gotta do helicopter under water escape training in Perth and a week of in house training before they send me off to a rig somewhere in the world!

After my first stint away, when I'm back I'll be looking for an EVO :D

Congratulations man,

What were your studies, i.e. what did you actually study and what cert do you hold?

Good stuff Kye, congrats! How long were your studies for?

And Luke.... gah, why do I bother :)

cheers mate, im stoked!

just a 2 year full time course mate. it made life hard not working and living out of home but its paid off big!

Congratulations man,

What were your studies, i.e. what did you actually study and what cert do you hold?

thanks man

i did my cert 3 in mining exploration and diploma in geoscience

sound boring but really interested me and would recomend it to anyone

as a trainee ill be on $2600 a month base rate plus $126 a day for ruffly six months then around $80k a year plus the $126 a day :D 12 hour days 2 weeks straight 2 off but could change.

Very nice income man :D Congrats and well done for someone to actually make use of their studies. So many people study these days and then end up working in a servo for the following 40 years :)

acid dipped ra ra ra block

stock crank fully balanaced and grub screwed

mahle pistons and rings

eagle rods

acl race bearings

ross race balancer (1000hp)

jun collar

n1 oil pump

oil restrictors

head is being sent off once i get it off for a full freshen up ($750)

WOOOP

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
    • Summernats cruiser?
    • Mark's a bit smarter than people give him credit... He'd convince the person that is to become dead, to drive him to the forest first. That way his car has no evidence in it, and he's free to dispose of their vehicle permanently how he sees fit too...
    • But if you had to go bury a body in the forest, would you not put that in the boot? Most of them are >=90kg these days.
×
×
  • Create New...