Jump to content
SAU Community

Recommended Posts

R32 GTR 1989 Model

Engine- Rb26Dett

2.6L Twin Turbo

5 Speed Manual

Reason for sale

Baught this car with intentions for a beautiful cruiser, but work circumstances have changed which leaves me with close to no time to drive, so decided to sell up :(

Speedo Says 35,000kms, but clearly isnt correct, but any check will show the engine is extremely healthy.

great Fuel Consumption- decent drive 1 tank can pull 460kms (just above empty)

- Extensive underbody work- sound deadner full underbody work

- after market coilovers

- brand new exedy clutch JUST installed

- New Light weight flywheel

- N1 spec GTR turbo's JUST installed(all brand new seals) never boosted

- new rear bushes

- mines pod adaptors and Pod filters

- replaced standard oil and water pumps

- aftermarket fuel pump

- N1 Slots on front Bumper

- FMIC

- 12inch subwoofer with Amp

- after market head unit

- 3inch fujitsubo jasma exhaust -nice and silent on idol and no drone on freeway.

- 3.5 down pipe

- resrpayed center console and air wents.

- car looks to have had a respray of wine red

- blue led dash lights

- Brand new Hicas lock bar

- Brand New tiny but powerful battery( $300)

- Polished Turbo pipe

- Resprayed 3peice of Rockers Covers( all seals replaced with genuine nissan gaskets)

- Viper Alarm system ($500)

- new brake pads

- Turbo Timer

Just did a service for new motul 300v oil, diff oil, brake fluid, wheel alignment, power steering oils, coolant flushed and new coolant.

Car is in great condition overall, welcome to compression test, i did 1 when i baught this car, but have only driven it about 3000kms since.

Issues: rear diff is beginning to whine a bit may need reconditioning.

Front bar now has a white scratch as i accidentally scrapped on a car in my house.

Head unit some reason stopped working after new battery was installed, havnt had time to look into it yet.

No RWC

REG till 2010 april

Price: $14,000 Neg

(NO TRADES)

Located South Easter Suburbs of Melbourne.

Call 0408288899 or sms or PM for inspections or questions

post-62461-1256470451_thumb.jpg

post-62461-1256470510_thumb.jpg

post-62461-1256470665_thumb.jpg

post-62461-1256470748_thumb.jpg

Edited by GT-R 32
Link to comment
https://www.sau.com.au/forums/topic/293499-r32-gtr-89/
Share on other sites

  • 2 weeks later...
  • 3 weeks later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...