Jump to content
SAU Community

Fs: Qld, 1999 Nissan Pulsar N15 S2 Sss 2.0l Manual Hatch

jmac

By jmac,
in For Sale (Private Whole cars only)

 Share

Recommended Posts

jmac Rising Star

jmac

Posted
Posted

Car: 1999 Nissan Pulsar N15 S2 SSS 2.0L manual hatch

Km's: 165,000

Condition: Good, see below

Price: $7,200 ONO - VERY NEGOTIABLE ON PRICE, make me an offer....

Contact: PM or text message 0407 171 337

Carsales link: http://www.carsales.com.au/all-cars/privat....aspx?R=7835382

Detailed info:

For sale is my SSS, it has been a great little car but I have purchased my next car and need a quick sale. I am a mature professional with 12 points on my license. Previous owner was a trained Nissan mechanic so the car has been looked after very well. Still runs very nicely and pulls very strongly.

The car is unmodified and I have serviced it every 5000km with 10W-40 oil. Also fresh brake & power steering fluids and NGK iridium spark plugs.

Always run on 98 octane fuel. Gets good economy, about 9L/100km in the city with the aircon on.

Has had front end done - both CV joints and control arm bushes done, now Superpro urethane items, at about 145,000km.

New front brake rotors and Lucas pads done a month ago at ABS. Rear brakes still 50%.

New front tyres and near-new rears (90%), Federal 535 all round. Wheel alignments done.

Can show receipts for these items.

Will sell with Sony CD/MP3/aux-in head unit and very good quality Pioneer split speakers with directional tweeters in front doors and Pioneer 6x9 speakers in the rear parcel shelf. These were professionally installed.

Car has two issues:

1. Minor accident damage on front bumper bar cover, will require new plastic cover but all other parts (lights, metal panels) intact.

2. Paint on roof has gone "off" and would need professional detail/respray.

For these reasons I am open to all reasonable offers. Need a quick sale!

I reckon this would make a great daily or second car for someone and it still has plenty of life left in it yet...

Please PM me here or text message to the mobile, thanks!

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      Wheel Sizes & Offsets For Skylines

      By GTSBoy · Posted

      9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • Dose Pipe Sutututu
      RB25DE NEO with Haltech ECU

      By Dose Pipe Sutututu · Posted

      post up screen shots of your injector tables
    • joshuaho96
      R34 25GT Engine Light 21

      By joshuaho96 · Posted

      Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • feartherb26
      RB25DE NEO with Haltech ECU

      By feartherb26 · Posted

      I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
    • Black_CSR
      Wheel Sizes & Offsets For Skylines

      By Black_CSR · Posted

      yeh they are 235/45/17 up front and 255/40/17 in the rears. I still didn't get my answer if i can fit a 18x9 up front. I want to get 4 of this and see if they will fit before committing as they didn't see an 18x8 as an option but there is a 18x9.5 also.   Enkei RS05-RR 18x9 35mm ET 5x114.3 75.0 Bore Matte Gunmetal Wheel
×
×
  • Create New...