Jump to content
SAU Community

Recommended Posts

PM user Yaah31 if you are NOR, he lives in Mount Helena, just got his done like 3 weeks ago, but i forget who by. The guy did a really good job and only charged $250 to do his car which is a 4 door, so will be cheaper seeing you have a coupe. Yaah31's car looks awesome now though!

Link to comment
https://www.sau.com.au/forums/topic/296710-window-tinters/#findComment-4942248
Share on other sites

Yeh dainsdabomb is good too, seen some of his stuff on some other Skylines, but he isn't mobile, you have to take your car to him. He quoted Yaah31 $250 as well, same as the the other guy except the other guy came to Matt

Link to comment
https://www.sau.com.au/forums/topic/296710-window-tinters/#findComment-4945948
Share on other sites

Maybe call TKO and ask them.

The only information in the Road Traffic (Vehicle Standards) Rules 2002 is :

Window tinting

(1) Glazing used in a windscreen of a motor vehicle must have a

luminous transmittance of at least —

(a) for a motor vehicle built after 1971 — 75%; or

(b) for another motor vehicle — 70%.

(2) Windscreen glazing of a motor vehicle must not be coated in a

way that reduces its luminous transmittance.

(3) However, subrules (1) and (2) do not apply to the greater of the

following areas of a windscreen —

(a) the area above the highest point of the windscreen that

swept by a windscreen wiper;

(b) the upper 10% of the windscreen.

(4) Glazing used in a window or interior partition of a motor

vehicle must have a luminous transmittance of at least 70%.

(5) Glazing in a window other than the windscreen may be coated

to achieve a luminous transmittance of not less than 35%.

(6) Glazing that has been coated to reduce its luminous

transmittance must not have a reflectance of over 10%.

(7) The luminous transmittance requirement in subrule (5) applies

to a vehicle instead of the corresponding requirement in the

relevant ADR.

(8) In this rule —

glazing means material fitted to the front, sides, rear or interior

of a vehicle, through which the driver can see the road, but does

not include a coating added after manufacture of the material;

luminous transmittance, for glazing, means the amount of light

that can pass through the glazing as a percentage of the amount

of light that would be transmitted if the glazing were absent.

Link to comment
https://www.sau.com.au/forums/topic/296710-window-tinters/#findComment-4967395
Share on other sites

AFAIK it's only light transmission (ah see above post :down:) so in theory colour wouldn't matter.

Of course, there's also the issue re 'mirror' tint or reflective films and light tranmission. The police can use a device which measures light transmissions through the windows...not sure if most cops use it or just yellow you to make you go to the trouble.

Link to comment
https://www.sau.com.au/forums/topic/296710-window-tinters/#findComment-4967430
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The incentives are mostly the same, yes. Ethanol is cheap compared to the cost of doing 98-100 RON with crude oil alone. 87 to 93-94 AKI all with E10. In 2020 Canada mandated E10 as a part of their "renewable fuel standard" and is supposedly going to go to E15 in 2030. In California where there are only 8 refineries with two threatening to shut down next year it's been over 20 years now of E10 and 91 AKI maximum because there's just not enough refinery capacity or crude oil supply relative to the demand for premium unleaded fuel. And CARB's low carbon fuel standard means functionally none of the diesel available at the pump is made from crude oil anymore. It's almost all entirely 20% biodiesel blended with 80% renewable diesel (hydrotreated vegetable oil) now. The number of gasoline vehicles that support E15 or higher ethanol concentrations is surprisingly low, I can't imagine it being wise to play tricks like this without flex fuel sensors in most of the fleet.
    • It's almost certainly the same as the one next to it. Have a fish around amongst these hits https://www.google.com/search?q=surface+mount+transistor+m33&sca_esv=9cb49794e0b2005d&source=hp&ei=2vJ5aNjTB7Kw0PEPldnS8QM&iflsig=AOw8s4IAAAAAaHoA6qkfmF6XcygtrZ4Vu9f92NXF_RFd&ved=0ahUKEwjYqIPP7MWOAxUyGDQIHZWsND4Q4dUDCA8&uact=5&oq=surface+mount+transistor+m33&gs_lp=Egdnd3Mtd2l6IhxzdXJmYWNlIG1vdW50IHRyYW5zaXN0b3IgbTMzMgUQIRigATIFECEYoAEyBRAhGKABMgUQIRigAUjKCFAAWABwAHgAkAEAmAHfAaAB3wGqAQMyLTG4AQPIAQD4AQL4AQGYAgGgAuYBmAMAkgcDMi0xoAfMBLIHAzItMbgH5gHCBwMyLTHIBwU&sclient=gws-wiz
    • South Australia, which is hardly as far behind as the rest pf Oz makes out, and who is also not a paragon of progressiveness (read that as over-legislation) in the area of vehicle standards, has this to say on the subject: Adjustable coil-over suspension Aftermarket adjustable coil-over suspension components are suspension units that incorporate an external thread on the main body and corresponding threaded spring saddle that allows the vehicle's suspension height to be varied. If fitting aftermarket or coil-over suspension components you must submit an Application to modify a light motor vehicle form and a report from a light vehicle engineering signatory (LVES).
    • Hi all, Long time since I've posted here. Looking for some advice on what I can remove to further identify the cause of my issues.  I can move the passenger seat forward and back but the knob used to adjust the seat angle is pretty much free spinning, there's very little resistance.  Removing the side cover I can see that the chain is intact but the shaft for the adjustment spins without the gear attached to it moving.  What's my next step for disassembly here? Is this a common fault? Just being a little cautious as I didn't want to start removing bolts for a spring to fly out or something equally as stupid.  Cheers
    • Those above shitboxes, mediocre and above usually have a turbo strapped to them, hence the slightly higher octane is required.  
×
×
  • Create New...