Jump to content
SAU Community

Recommended Posts

CEAP CHEAP CHEAP

the car is a silver nissan skyline r33 series2 1996 model.

i have everything from where the front doors start from. to the back of car (no engine or gearboxx)

i have series 1 full interior

etc msg for parts number is : 0432-568-279

hi mate

i'm looking for boost sensor + triple harness to gauge. and oil temp sensor as well.

lemme know how is it going.

thanks.

CEAP CHEAP CHEAP

the car is a silver nissan skyline r33 series2 1996 model.

i have everything from where the front doors start from. to the back of car (no engine or gearboxx)

i have series 1 full interior

etc msg for parts number is : 0432-568-279

wrong number or u arent replying to msg's?

Hello,

How much for boot at rear bar?

Thanks, Dannie

CEAP CHEAP CHEAP

the car is a silver nissan skyline r33 series2 1996 model.

i have everything from where the front doors start from. to the back of car (no engine or gearboxx)

i have series 1 full interior

etc msg for parts number is : 0432-568-279

just wondering if u had these parts driver side window switch, glove box plus the clips for the hinges heater core unit insde the dash rear seats driver side head light all the carpet boot trim charcoal canister air box and snorkel no:040301187 im in melb

CEAP CHEAP CHEAP

the car is a silver nissan skyline r33 series2 1996 model.

i have everything from where the front doors start from. to the back of car (no engine or gearboxx)

i have series 1 full interior

etc msg for parts number is : 0432-568-279

Mate, if you're not going to respond to your PM's, thread responses and SMS phone messages then don't bother posting up a sale thread...ffs. ;)

Guest
This topic is now closed to further replies.


  • Latest Posts

    • I like they don't raise their hands into the air when they shift their sequential boxes, seems to be a thing here in Australia lol...
    • I'm not normally one for posting random videos, but I thought we'd all appreciate the honesty about how broken our cars tend to be lol. Genuine skyline life here.   
    • New CAS just turned up from NZ Wiring. Looks like a nice bit of gear.  So, yeah. Triggered, bro. Realised I may as well do the cam belt while mucking about with it so will order one of them.
    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
×
×
  • Create New...