Jump to content
SAU Community

Recommended Posts

I got an S-AFC soon after getting my mildly modded car (T04 turbo, exhaust, boost controller, small FMIC) and it gave me a uniform extra 15rwkw across the board.

Then after a few more mods, which were a bigger FMIC, new front facing plenum, bigger fuel pump, upgraded wastegate actuator to handle more boost, and running higher boost, the car got 2 massive dips in the powerband even after re-tuning the S-AFC. I had more power up top, but it felt very flat after 5000rpm or so.

At this stage I upgraded to a PowerFC and it's fixed it. And I haven't even tuned it yet. I don't think it was a case of the ECU and S-AFC not handling the power, I just think the airflow was so radically different from stock that caused it to have a bit of a sad. There are other guys running over 215rwkw with S-AFC and no problems. Part of it is luck.

I say you should get a second hand S-AFC, and when the car starts not coping, sell it and get a PowerFC.

I know PowerFC is defectable in SA but is the SAFC?

are you serious?

how can the defect u for a PFC

coppers rip off ur kick panel and go "show me ur ECU"?????

its gettin beyond a joke this defect bullsh*t

Oh another question, with cam gears do you need a aftermarket ecu to run after market cam gears?

You don't need an aftermarket ECU to run adjustable cam gears but it may help. I installed mine and I found that the best setting was on 0 degrees (ie same as factory). This may change after tuning though.

You can't easily tune them yourself at home, best to do on the dyno where you can monitor the air fuel ratio so you don't run it too lean. If you know how to use a dyno properly it should take around an hour, otherwise give it to the workshop and they'll charge you around $200-300 for the same thing.

2GU UP

I am dead serious, the cops don't pull off the kick panel.

But the Registration office that does the inspections for defects will pull your car apart looking for stuff like this.

I have even heard of inspectors undoing the casing to look at the circuitry on the ECU to check that it is standard. You would have to be desperately unlucky I would imagine.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
    • Either the bearing has been installed backwards OR the gearbox input shaft bearing is loosey goosey.   When in doubt, just put in a Samsonas in.
×
×
  • Create New...