Jump to content
SAU Community

[11th Dec] R32 Skyline Club Cruise


Recommended Posts

An Introduction Cruise to a new owners club for enthusiasts with R32's

Place: Morley Galleria

Time: 11th December 2009 - 8.00pm for 8.30 Leave

Bring a tank of fuel

The Cruise is intended for owners of R32 Skylines,

however I am not going to tell you to leave if you bring a different model of Skyline, but Skylines only please.

Bring a sensible attitude, those who act inappropriately will be asked to leave.

See you there!

Link to comment
https://www.sau.com.au/forums/topic/298750-11th-dec-r32-skyline-club-cruise/
Share on other sites

I own an R32 but it's not on the road at the moment.. and my daily isn't a Skyline :P

I think the Stagea should be accepted but thats up to the organizer.

Will see how i go for this one.

An Introduction Cruise to a new owners club for enthusiasts with R32's

Place: Morley Galleria

Time: 11th December 2009 - 8.00pm for 8.30 Leave

Bring a tank of fuel

The Cruise is intended for owners of R32 Skylines,

however I am not going to tell you to leave if you bring a different model of Skyline, but Skylines only please.

Bring a sensible attitude, those who act inappropriately will be asked to leave

See you there!

Hey Bangn

As My son is R33 skyline owner and is on his leaners permit can he drive on your cruise or do you have rules about leaners?

Hey Bangn

As My son is R33 skyline owner and is on his leaners permit can he drive on your cruise or do you have rules about leaners?

Sorry, I am sure you will understand but to protect peoples prides and joy I am going to have to say no. Accidents do happen, and I dont want it to be my car nor anyone elses. Once he gets his P's he is quite welcome but even then I think it would be worthwhile for his sake to undertake some advanced driving days so that way everyone feels a bit safer around a new driver.

Edited by BANGN
Sorry, I am sure you will understand but to protect peoples prides and joy I am going to have to say no. Accidents do happen, and I dont want it to be my car nor anyone elses. Once he gets his P's he is quite welcome but even then I think it would be worthwhile for his sake to undertake some advanced driving days so that way everyone feels a bit safer around a new driver.

Agree'd, no 33 L platers

Might not be able to make it :) Got a team meeting tonight starting at 6:30.. if I can get out of there early I'll head on down.

Actually.. Tom.. grab me a spare map and I'll ring ya when I'm done :ninja:

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Hi. This is just my curiosity because iam sure the tuner figure something out...but either way i want to ask. The "problem" is that the Nistune ECU (Stagea FW and RB25DET NEO from Stagea) sees many times the speed than the speedo does(he says the speedo show 120 km/h - correct speed and the ECU shows like 510km/h ) I told him that this car/tranny getting speed from rear diff. If iam not mistaken the RB25DET NEO "need" to see tranny speed sensor? (my tranny has the plug for it). So couple of "question" If he connects/wire the speed sensor to the tranny...are the signals gonna intervene and if...what if he disconnects the rear diff one and the speedo stops working? Or the "new" sensor from the tranny "take over" and will not going need the one from diff? As i said i know he figure/get that done...iam just curious to know what are the solutions 🙂 
    • Your IACV is set to idle too low. You need to adjust it via the screw Duncan mentioned. From memory it should be 650rpm with the valve electrics unplugged. What is it trying to idle at with the IACV plugged in?
    • Ahhh, I need the whole head unit. I definitely needed to roll back through and review your setup, ha ha! Neat setup they have going on. I just need a full double din head unit. But I want good and responsive. I might have to review what the likes of pioneer have out these days.
    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
×
×
  • Create New...