Jump to content
SAU Community

Recommended Posts

I dont know what the probl;em is,

when its cold i cant run it at all

it sounds like its suking sooo much air its not funny,

i have ba boost cointroller set to 8psi and 14psi,

8 psi goes harder than the 14 cause when is on 14 it just pops and farts all over the place.

also i dont think a rb25det running 8psi sould get beatn by a n/a 2001 astra.

im really starting to get shitty cause its only 3 minths old and runs like a heap of shit.

mods done

3in HKS super dragar exhaust from turbo

Turbosmart 2 stage boost controller

Water injected onto standard cooler

Fuel cut defender

Pod air filter

BOV

was wondering if there is any one in the hills district that could come and have a look at it, its wurrying me and itys a pain when you get beating by a S**T box.

R33 GTST

Late series 1

Thanx Craig

0410 635 901

Link to comment
https://www.sau.com.au/forums/topic/29906-car-runs-like-a-dog-0-need-help/
Share on other sites

yea serviced it about 3000 ago myself, i dont trust any1 else with a car like that.

Jay - yea its aftermarket, not sure what type just was sitting in my mate garage at home, how do u adjust it?

i could email you piks if you want

Like J said your BOV could be leaking air therefore making your AFM readings incorrect. Lots of people experience stalling issues because of this.

As for the Flat spots at high boost I'am with muffas in saying that your plugs could be F*cked or they may not be gapped for high boost (.8). Remember that the inlet cam changes it posi to increase the pull at 4500 rpm which will also be contributing to your flatties becuase the fuel fixture really get rich when this happens.

So i guess if i was you i would:

1) close after market bov, or borrow standard one?

2) Check & gap plugs

3) Wind the boost down to 12psi (R33 stock computer will perform ignition cut (what people call boost cut) any where from 11psi to 14psi depending on the particular car) I am not sure if you fuel cut defender will stop this?

4) Get SAFC to lean out A/F ratio at higher RPMS.

Hope this actually helps & iam not just full of Sh*T :-}

Good luck with it all

OK, before getting a (apexi Super AFC used for adjusting A/F ratio's about $700 bucks? not sure)

Try turning your boost down to about 12psi, In most cases the standard turbo on an r33 will not run efficiently at 14 psi and may even produce less power at 14 psi. Untill you get you car dynoed at the different boost levels you wont know for sure but i would run 12 psi for now to try and resolve your flat spotting.

Also see if you can get that stock BOV to try and solve your starting issues.

If turning the boost down does not solve your problem it could be that one of your coil packs are shagged :-{, once again getting one of a mate to do some tests would be your best bet as you dont want to waist money buying coil pack (about $125 sh)...

I say sell your car and buy an astra. :)

But seriously, how much research did you do before just upping the boost to 14psi on the stock cooler? Then you just chucked a BOV you had lying around on?

And now you're having problems? What did you expect?

What sewid means is:

The stock cooler is very un-efficient, therefore when your boost gauge says that you are at 14psi your turbo is probably (for args sake) pushing out say 16psi or maybe more!

I know a lot of people will tell you that you can run 14 psi of a stock r33 turbo and to my mind they are right, just make sure that you have a after market cooler that is reasonably efficient before doing so.

Remember: You might achieve more power by running a little less than 14psi with a stock turbo...

What sewid means is:

The stock cooler is very un-efficient, therefore when your boost gauge says that you are at 14psi your turbo is probably (for args sake) pushing out say 16psi or maybe more!

I know a lot of people will tell you that you can run 14 psi of a stock r33 turbo and to my mind they are right, just make sure that you have a after market cooler that is reasonably efficient before doing so.

Remember: You might achieve more power by running a little less than 14psi with a stock turbo...

Right.

The stock cooler is not going to be able to cope with 14psi. The air is therefore going to be less dense and you will not be seeing the performance you should.

To compound this, is your pod filter in a enclosure or partitioned off from the engine bay? If not then again you will be sucking in enormously hot air from the engine bay.

All of this spells hot air in the engine, meaning crap all improvement over a stock car.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sounds more like what Brad said, that it's mainly transfer. What pad bed in procedure did you use, and did you replace/machine the rotors, or just swap pads?
    • The stutter is almost entirely in the pedal. I don't feel the brakes release and reapply as you would with ABS engaging but the pedal feels that way, without the brakes releasing. It only lasts for less than a second and the pedal is fine again. It's hard to explain, sorry.  I'll get under this weekend and just double check everything is tight. Fluid is at max where I left it.
    • What bedding in procedure did you use?   When you say stutter, what exactly do you mean? Like it feels like someone letting go of the brakes momentarily and regrabbing them again to get you to stop? Re-reading your post, and that is what it kind of makes me think you're explaining, like theres a little bit of a jolt, likely just as you're reaching a stop. I've only had this issue once. And if its caused by what caused mine, you will want to get the car up on stands again and check it over. Mine was a case of a caliper mounting bolt coming out and letting the caliper rotate on the other remaining bolt and gave play in a wheel as it came to a stop. But not every stop either!
    • Yeop... binned it   This will be a summary will not many pics atm and cbf  Fixed the samsonas - it was totally munched Put a new precision 7675 T4 on with proper split pulse mani Got to Sydney to get to car - drove to canberra to get racecar - drive back to sydney that night Next day all day at Plasmaman putting on new clamps cleaning some things up and adding another large engine oil cooler sitting at the rear above diffuser to keep things cooler Next day - Tuesday - on Dyno - killer wikid awesome pumped out really good numbers - more mid range and on lower boost levels Wednesday - first prac - all day again getting the suspension right - had to borrow front suspension again - out do a lap come in - out do a lap - in - what i had just couldnt handle the load at the more consistent higher speeds - got a lap in at the end of the day that was pretty reasonable  Put it this way that lap wouldve had me in 4th in Pro am for the whole event - with only 700 hp and used tyres Thurs first official prac day - lap out warm up - then entered a hotlap with above setting and 80% effort took corners 1,2,3 and into 4 car felt awesome -  rear came around out of nowhere bang into the wall near front on at whatever 140 kmph Done, over, gone Just one of those how did that happen apparently as all indications show nothing out of the ordinary Got to spend the rest of the time at the event like I hadnt done before - was actually Ok mainly as I had my family and my boy is 9 and got treated like a rockstar Long trip home, lost a trailer wheel in nowhere land, X5 airbag suspension gave up half way across nullabour and rode on bumps stops (its now completely fine) had to do a 19 hr drive day on day 3 as accommodation got screwed up so just had to keep driving till found a town with some Now to reassess - hopefully the motor and other things are OK but yet to be seen too. There is no easy fix there is no i'll just order that part and get it sent - we'll have a talk to people see what can happen and what the go is but at minimum its rebuild from scratch struts forward and alot of time effort and $ should and if I return and if but maybe/ when  I have the cage tied into the front strut towers - if I didnt have that things couldnt been worse you can say its just a front end but if you know what goes into these cars... you'll know what that actually means in reality   Car was very fast. Disappointing we just didnt get to show it Effort doesnt win you races though     Apparently this is motorsport !  
    • Thanks, will do that.  Thankfully they still feel great.
×
×
  • Create New...