Jump to content
SAU Community

Recommended Posts

plugs are new (gaped 0.8), well im going to see if new coil packs will make a difference, car has been misfiring on full boost or about 3500 4000rpm

Edited by Flash89
  • 2 weeks later...

well new coilpacks fixed the misfiring prob. no difference with the cold start

yeah when i do the idle adjust. car is prob reving around 900rpm take the tps plug off the car raises idle tp about 1200-1300 when i screw in the idle screw the rpm dont change at all. even tho the screw is all the way in too.

in the oil thread everyone has pretty much agreed that 10w40 is good for rb25's

but a 5w40 would be better again being thinner when cold

pull the air regulator (under the throttle body) out and give it a clean, make sure it goes all the way closed too (there is an adjuster)

also pull the iac valve off (one with the idle screw on it, at the back of the plenum) and clean it

clean both of them with carby/throttle body cleaner

The spring in the AAC valve should move freely. Also check the voltage on the solenoid.

Not sure about the air regualtor, I have two of them and they both cause bad cold starts. I actually think the spring is stuffed as the small bi-metallic disc does not fully close. Anyone know if this disc is supposed to remain closed with no voltage?

This thread is great when diagosing similar problems. http://www.skylinesaustralia.com/forums/Fi...ob-t174735.html

when ur car starts in the cold what rpm does it sit at and when it is hot what rpm does it sit at when start

it is easer to start when hot

what volts do u get with everything off and what it the voltage drop when u try to start and what type of battery do u have and how old is it

lets try to get this fixed.

i used to have the same problem.

Try adjusting the mixture screw... i think thats what its called. Its the screw on the manifold, on the same unit as the aac valve but on the other side. Wind that out a few turns, then start her up. If you still have trouble, get the car to temp and check your timing. I did this and new plugs and it fixed her right up.

However, it took a few goes to get it right with that screw, it progressively got better and better as i screwed out so i just did it one turn at a time. 2.5 turns got her perfect for me.

Mine was fully screwed in at first and therefore letting no air in and flooding i think... sounds like the same for you.

  • 2 weeks later...

i think you are talking about the idle screw. and yes i do disconnect the tps when i try adjust the idle still, the rpm stays the same.

yes it fires up straight away onces its warm.

battery is like 3months old and its massive, 4x4 battery. dont ask why i just replaced the same battery that was in there before

what i would also like to do, what is the difference with cold and warm starts, like with cold starts does it give less air cause its cold which means the air would be denser??

well i think we should rule out the battery ?

do u have a multimeter?

and or a

battery tester?

if battery tester test battery to see if u have enough CCA's

if multimeter then its a bit tricky. ideally you would use the battery tester but if thats not an option then make sure the battery is fully charged. attach multimeter u should read about 12.7V and wile reading the multimeter try and start the car if voltage drops bellow 10V it might be a good idea to take it to ur local auto 1 to have it tested there.

if the battery looks angry then replace and also check your alternator. all this is. is a multimeter attached to the car with it running and you should see between what 13.5V and 14.5V then turn on head lights. the voltage should drop for a second then come back up. also check for current draw. this is the multimeter attached in series to the battery with every thing hooked up but off, set multimeter to amp's setting.

next is your air filter clean? if not clean it

have u recently cleaned your AFM if not clean it.

oil change try something with a lighter weight at cold temp

setting the A/C to "cold" will help even if u leave the A/C off because this will make your coolant bypass the heater = faster warm up

  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...