Jump to content
SAU Community

Recommended Posts

Hi all

goin to do a oil change on my r32 gtr 2mora. Im running Mobil 10-30. changing to Motul V300 10-40. and ill be using this oil from now on.

My question is should i use some of that Nulon Oil engine flush before i drop the mobil oil out, than make sure i let it all drip out as much as poss, before refilling with motul?

or is that stuff just a waste of time, and should i just drop the oil and let it drip, than fill her up.....

all this is including changing the oil fitler as well of choose.

cheers

Deano :banana:

Link to comment
https://www.sau.com.au/forums/topic/302587-should-i-flush-the-oil/
Share on other sites

I have never used a flush inbetween oil changes, have heard discussion that if the engine isn't in good health and you try a flush it can dislodge sludge and block oil galleries. But I think this would be pretty rare. I'll quite often drain the oil, then pour 100ml or so of the new oil through the engine to drain out anything that might be sitting at the bottom. Then plug and fill with new oil.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hey guys Long time lurker, I daily a nm35 stagea 250t rs four and I've had it for almost 2 years (very reliable 👌). Issues or just looking for information ill always find myself here having a read, so thought id join.  3inch stainless intake, pod filter, AM performance turbo dump pipe, 3inch hotdog, 3 and half inch stainless to 3 and half inch AM performance blast pipes. Bc racing coilovers. 18inch rims Hdi intercooler and trans cooler soon.  Here's my car
    • thanks for the advice on the box... i was thinking the 6 speed was better for cruising on the highway but on closer inspection and comparison the Rb 5 speed box was not too different...  So the choice is going to be the RB25 box... if I can save up and find one at the right price  
    • Thanks Matt, yes that's what i am aiming for. Just going to apply the right voltage and grounds to the dash connector. Hence my search for these pins... any chance you know if these pins are in the same spot as the ones on the S15 Dash connector? as mentioned above on page 8?
    • Yes, unfortunately that's the one. Signal was noisy to begin with; after driving once and looking back at the logs I saw pressure constantly swinging between 0-200psi, or staying at 0 randomly for a few seconds. There's a lot of good sensors that share the same look and feel, so don't presume they're all bad. I bought mine for 20$ off Amazon and I should have read the reviews prior, as it's clear they're junk.  I purchased a lowdollerr motorsports sensor. 
    • wedding eh.....I seem to get to more funerals than weddings or christenings these days....
×
×
  • Create New...