Jump to content
SAU Community

Recommended Posts

I ordered and paid for a plenum roughly a week and a half ago and haven't had any communication since then.

Has anyone else ordered through them?

How long did it take you go get your stuff?

Did they return your emails?

Just give them a call mate ,,easyest way and then youll know whats going on..........

Link to comment
https://www.sau.com.au/forums/topic/304406-plazmaman/#findComment-5041270
Share on other sites

alot of places only just came back from the christmas break this week, if you just ordered over the internet without calling them to make sure they were open or to make sure they are in stock then thats your problem.

Link to comment
https://www.sau.com.au/forums/topic/304406-plazmaman/#findComment-5042019
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Keeping in mind that for most people this is a week to month long job!
    • Its also worth mentioning that 30 years after it left the factory and god knows how many missed oil changes since, there is every possibility that one or more lifters are ticking because they are sticky/gummed up. To resolve that you need to pull the cams then pull each lifter, disassemble, clean, reassemble, soak in oil and re-install, and they should come up good as new.
    • What air filter are you running? Is it a panel filter in the stock air box, or a pod filter? Is the air filter the type that is oiled?   If you unplug the IACV, what rpm does the engine idle at?
    • Reading through the engine service manual their advice is do a cylinder balance test. Unplug one injector at a time and see if the idle drops a consistent RPM. You can also do this using a Consult cable which is easier. They also call for unplugging the power transistor, then with the engine off and the fuel rail unhooked from the manifold verifying that you have good fuel flow (even injection, no dripping/leaks, etc) when you twist the CAS by hand. Also verify the spark by pulling the spark plugs and allowing the plugs to ground and turning the CAS by hand. I would also start doing the sensor checks and idle valve checks in service manual. Make sure the MAF tests reasonably, the intake air regulator is sane, etc. You may have to get new spark plugs.
    • This sounds very old of me, however since buying the Tiguan shit box, my view on shit boxes have changed.
×
×
  • Create New...