Jump to content
SAU Community

Recommended Posts

Bolt together R33 GTR Roll Cage. (high quality as new)

6-point with rear diagonal.

You can leave out the front members and ceiling crossmenber for a 4-point.

All powercoated red...rear diagonal black.

$750

Phillip

[email protected]

0409573124

Link to comment
https://www.sau.com.au/forums/topic/30682-r33-roll-cage/
Share on other sites

I don't have any Pic's of the cage installed...it was fitted to the second of my GTR's which was setup for circuit, but still had the full interior. This car was sold without the roll cage, suspension and a number of other items. Will fit with the full interior.

Link to comment
https://www.sau.com.au/forums/topic/30682-r33-roll-cage/#findComment-624517
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You're already well into "gearbox is a consumable" territory there. A billet plate will either make it (effectively) 1% stronbger or make it last one more pass. At some point you'll probably tear 3rd gear into small chunks and regret all the life decisions that came before it.
    • ..and forum.r31skylineclub has been down all week....anyone know why?
    • I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
×
×
  • Create New...