Jump to content
SAU Community

Recommended Posts

Guys,

I recently had my motor rebuilt (actually a new 2nd hand motor rebuilt) and i was thinking the other night my insurance & rego wont reflect the new number and thefore went out to inspect it .Mind you it was a bit dark but i had a torch of sorts but for the life of me cant seem to find where abouts its located.....

Does anyone know where the engine number is on the above mentioned motor?

Regards,

Darren

Link to comment
https://www.sau.com.au/forums/topic/309240-r33-rb25det-engine-number/
Share on other sites

RB25 is on the passenger side. Bottom of the block near the bell housing. It is on 2 machined surfaces. The first will have the RB25 and the second will have the number. You will need a torch and some degreaser if its dirty.

Damm its hard to get into that area , How the hell do you do it. (easy if motor out but.....)

Dazza

when you know roughly where it is.

stick your camera down there much easier than getting down there yourself!

RB25 is on the passenger side. Bottom of the block near the bell housing. It is on 2 machined surfaces. The first will have the RB25 and the second will have the number. You will need a torch and some degreaser if its dirty.

my bad :P , for some reason i was thinkin rb26, must of been along day for me lol.

sorry to missinform you darren.

rb25 is on the pass side where shadz said.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
×
×
  • Create New...